Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > General Information > Electrical / Radios

Electrical / Radios Discussion of electrical systems and accessories.

Reply
 
Thread Tools Display Modes
  #1  
Old 26-06-19
DrewW DrewW is offline
Member
 
Join Date: Nov 2011
Location: Gold Coast
Posts: 53
Default Interior lights not working

Most of the interior lights on my SWB NS have suddenly stopped working. The only ones still working are the Luggage Compartment Lamp and the Door Courtesy lamps. I have done the obvious and swapped over the 15 amp fuses numbers 18 and 20 in the Manual to no effect. As I can't envisage half a dozen or so globes blowing all at once I am stumped. Could it be one bulb blows and renders the rest of some circuit inoperable? Any advice much appreciated.
__________________
NS SWB 3.2 DiD Auto. 2" lift, King springs, Bilstein shocks, Bushkinz bash plates, Airtek snorkel, BRC breathers,TJM Bullbar, 12000lb Grande Winch,Tyredog TPMS,Nomad valve body & TC lockup kit
Reply With Quote
  #2  
Old 26-06-19
RUGGA RUGGA is offline
Valued Member
 
Join Date: Nov 2014
Location: Adelaide
Posts: 1,395
Default

While checking fuses, check the hazard fuse; on the Gen 3s it affects all sort of electrickery.

Have you towed recently?
__________________
02 NM 3.2, Auto, Exceed, I/C and sump guards, L&B 2" lift, 265/75/16 OPAT2.
Reply With Quote
  #3  
Old 26-06-19
aussieintas's Avatar
aussieintas aussieintas is offline
Valued Member
 
Join Date: Feb 2013
Location: Sorell, Tasmania
Posts: 1,723
Default

The globes are defo NOT in line so not that bud.

Have you got one of the globes out to check it?

Have you done any work on the Paj at all in recent times?
__________________
2008 NS X SWB DiD auto in cool silver, Pirelli Scorpion ATR's, MCC bull bar with Stedi Summit fog/DRL's, Airtec(TJM) snorkel.

Previously
88 NF SWB 2.6 manual
92 NH LWB 3.0 auto
92 NH J-Top 2.5 manual
95 NJ SWB 3.0 auto
99 Cruiser 4.5 manual with all the fruit
Reply With Quote
  #4  
Old 27-06-19
DrewW DrewW is offline
Member
 
Join Date: Nov 2011
Location: Gold Coast
Posts: 53
Default

Just checked the hazard lights and all ok there. I have towed the van recently but can't recall whether the lights failed before or after I towed. From memory they worked one day when I parked the car and did not work the next morning. No work has been done recently on the car.
__________________
NS SWB 3.2 DiD Auto. 2" lift, King springs, Bilstein shocks, Bushkinz bash plates, Airtek snorkel, BRC breathers,TJM Bullbar, 12000lb Grande Winch,Tyredog TPMS,Nomad valve body & TC lockup kit
Reply With Quote
  #5  
Old 27-06-19
DrewW DrewW is offline
Member
 
Join Date: Nov 2011
Location: Gold Coast
Posts: 53
Default

Just read the following:

Mitsubishi NS, NT, NW and NX Pajero: lamps may not operate
In June 2016, a recall was issued for Mitsubishi NS, NT, NW and NX Pajero vehicles because the turn signal and lighting switch connector terminals could become worn during switch operation due to insufficient rigidity this could result in an accumulation of oxidised dust on the connector terminals. Furthermore, excessive dust accumulation could act as an insulator, affecting terminal conductivity. Continued usage in this conduction could cause conduction failure such that the following may fail to operate or only operate intermittently: the headlamps, turn signal lamps, parking lamp, fog lamps, tail lamp, number plate lamp and cabin lamp (PRA 2016/15466). The recalled Mitsubishi NS/NT/NW/NX Pajero vehicles had VINs in the following ranges:
JMFLNV97W7J000101 to JMFLNV97W9J000125;
JMFLNV98W7J000101 to JMFLNV98WFJ000109;
JMFLYV97W7J000101 to JMFLYV97WDJ000113;
JMFLYV98W7J000101 to JMFLYV98WFJ001707;
JMFMYV87W7J000101 to JMFMYV87W9J000131; and,
JMFMYV88W7J000101 to JMFMYV88W9J000181.

My car had this recall done in Jan 2017. As cabin lamp is mentioned above could this be my problem?
__________________
NS SWB 3.2 DiD Auto. 2" lift, King springs, Bilstein shocks, Bushkinz bash plates, Airtek snorkel, BRC breathers,TJM Bullbar, 12000lb Grande Winch,Tyredog TPMS,Nomad valve body & TC lockup kit
Reply With Quote
  #6  
Old 27-06-19
Seigried Seigried is offline
Valued Member
 
Join Date: Apr 2016
Location: brisbane
Posts: 486
Default

It is entirly possible. You could remove clean and reinstall the indicator switch to see if it fixes the problem.

Sent from my SM-G900I using Tapatalk
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Interior lights on 2006 Pajero not working? stevefromqld Generation 3 Pajero 3 20-10-16 08:43 PM
Interior LED lights jhale101 Generation 4-3 Pajero 6 19-06-16 07:36 PM
LED interior lights top end tourer Electrical / Radios 11 23-01-16 12:48 PM
Fuse for trailer lights? - dash lights not working turbopiston PB -PC Challenger 2009 - 2014 9 31-01-13 01:39 PM
New LED interior lights averhamme Electrical / Radios 0 01-11-11 04:51 AM


All times are GMT +10. The time now is 02:20 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.