Tweet
Hi all
Just a quick review on TJM snorkel for an NS. Not doing a full install post as there is plenty on this forum. Instructions were good and templates were spot on. Took my time doing it including waiting for the rust preventative paint to dry on the cut and drilled holes.
I went down the modifying the original washer bottle line thats previously been talked about. Pretty easy once holes are cut in the wing, replace washer bottle and use pen to draw what needs to be cut. I then used part of the supplied washer bottle to replace the cut bit, couple of cable ties and sikaflex to seal.......worked a treat.
Had to temporary remove my catch can due to where the inlet comes into the engine bay. Once i get chance to make a bracket to fit catch can on firewall I'll reinstall it.
No real problems along the way, happy with the fit and finish of the TJM snorkel. Please feel free to ask any questions regarding the install.
Just a quick review on TJM snorkel for an NS. Not doing a full install post as there is plenty on this forum. Instructions were good and templates were spot on. Took my time doing it including waiting for the rust preventative paint to dry on the cut and drilled holes.
I went down the modifying the original washer bottle line thats previously been talked about. Pretty easy once holes are cut in the wing, replace washer bottle and use pen to draw what needs to be cut. I then used part of the supplied washer bottle to replace the cut bit, couple of cable ties and sikaflex to seal.......worked a treat.
Had to temporary remove my catch can due to where the inlet comes into the engine bay. Once i get chance to make a bracket to fit catch can on firewall I'll reinstall it.
No real problems along the way, happy with the fit and finish of the TJM snorkel. Please feel free to ask any questions regarding the install.
Comment