Below Nav Bar Ad Module

Collapse

Pajero Air Filter

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • dhula
    Valued Member
    • Sep 2012
    • 1196
    • South of Perth

    #16
    Here is some light reading

    Thread one

    Thread two
    2010 NT Activ, DiD+lazy shift. Bushskins+Boo's, Kings springs+Monroe shocks+Firestone Airbags, MM towbar, MM nudgebar.
    2006 KJ Cherokee, CRD+lazy shift. Ironman springs and OME shocks, MoPar skids.

    Comment

    • littleriver
      Valued Member
      • Jan 2013
      • 3339
      • Queensland

      #17
      Originally posted by gemster View Post
      So how much are original filters from Mitsubishi ?...

      Gemster....
      Call them ask for trade. .
      2012 PB Challenger LS (Manual) Safari Snorkel, OZtec shocks front & rear with King Springs (lift 2 inch) , 22 inch light bar on ECB Nudge bar, roof racks & basket, Bridgestone Duelers 697 LT A/T (116S), Uniden Dash cam, Oricom 2 way radio 80 channel, Ipod connected via glove box usb, Waeco cf50, Garmin gps (with topo), Opticoat + paint protection, Nilrust proofing, Roosystems Ecu Remap

      Comment

      • NTBenny
        Senior Member
        • May 2017
        • 365
        • Newcastle

        #18
        Originally posted by dhula View Post
        Here is some light reading

        Thread one

        Thread two
        Very interesting. Thanks for posting.

        Benny
        2011 NT Pajero Platinum, DCS 80AH Extreme Battery, Stedi 8.5" LED driving lights, Bushskinz side steps & bash plates, Provent 200, Auto-mate TC lockup, Derale fan forced trans cooler, custom 3inch exhaust, JT intercooler, Bilstein + Lovells 2 inch lift, Airbag Man bags, DBA slotted rotors, braided brake lines, diff+gearbox+transfer breathers, Redarc boost & EGT gauge, Tuned by TME 141rwkw 598nm.

        Comment

        • benckj
          Valued Member
          • Oct 2017
          • 517
          • Alexandra , New Zealand

          #19
          Originally posted by NTBenny View Post
          Very interesting. Thanks for posting.

          Benny
          It was a good read. Think I'll check mine more closely as its an aftermarket cheapy that reaplaced my OEM.

          jim

          Comment

          • NTBenny
            Senior Member
            • May 2017
            • 365
            • Newcastle

            #20
            So when I bought my Paj mid last year it had just been serviced with a new air filter. Not sure on the brand but it says "Made in Indonesia" written on it. I bought a Ryco filter but had not installed it yet as the current filter still looked in pretty good nick. After reading the above today I decided to remove and measure the thickness of the seals on both filters. "Made in Indonesia" filter was 10mm and the new Ryco was 12mm. I inspected the box internals and could not see any signs of dust getting past the filter. I don't drive dusty roads very often though. I've since decided to ditch the Indonesian filter and install the Ryco which I will monitor over the coming months.

            Benny.
            Last edited by NTBenny; 30-01-18, 05:40 PM.
            2011 NT Pajero Platinum, DCS 80AH Extreme Battery, Stedi 8.5" LED driving lights, Bushskinz side steps & bash plates, Provent 200, Auto-mate TC lockup, Derale fan forced trans cooler, custom 3inch exhaust, JT intercooler, Bilstein + Lovells 2 inch lift, Airbag Man bags, DBA slotted rotors, braided brake lines, diff+gearbox+transfer breathers, Redarc boost & EGT gauge, Tuned by TME 141rwkw 598nm.

            Comment

            • twisted32
              Senior Member
              • Jan 2015
              • 303
              • Adelaide

              #21
              Made in Indonesia sounds like the Donaldsons I use. The seal does become compressed once used vs new as I have measured them.
              MY14 GLX Pajero DID auto with Lift, 265/70 R17 Yoki X-AT's, Full Bushskinz plates , Scotts Rods 3" TBE, Johnny Tig FMIC, TME ECU remap, Provent, OL Bullbar, Ironman 9500lbs winch, dual batteries, Lockup mate lite, nomad valve body, aeroflow AF72-6000 transmission cooler with 9" fan and radiator cooler bypass, 3.15 reduction gears, traction contol mod (on/off), Uniden 8080S, flappy paddles, Rhino flat rack mounted on ARB rails, 42" Stedi ST3K light bar and custom drawers

              Comment

              • NTBenny
                Senior Member
                • May 2017
                • 365
                • Newcastle

                #22
                I know the shop who serviced it but unsure what filter was used. They installed a Sakura oil filter so I'd imagine the air filter was about the same level of quality.

                Benny
                2011 NT Pajero Platinum, DCS 80AH Extreme Battery, Stedi 8.5" LED driving lights, Bushskinz side steps & bash plates, Provent 200, Auto-mate TC lockup, Derale fan forced trans cooler, custom 3inch exhaust, JT intercooler, Bilstein + Lovells 2 inch lift, Airbag Man bags, DBA slotted rotors, braided brake lines, diff+gearbox+transfer breathers, Redarc boost & EGT gauge, Tuned by TME 141rwkw 598nm.

                Comment

                Matched content

                Collapse
                Working...
                X