NM Cargo Door Seal

[Guest]

Hi all,
I can't seem to find any substitute rubber seal for the cargo door. The body seal is fine but there is no seal on the actual door. Most "D" seals on the like of eBay seem too wide on the base and not high enough. From what I've measured I'd need at least 25 mm to get a seal.
Anyone know where I can get some from? MM of course being the last resort..

[spot01]

Hi all,
I can't seem to find any substitute rubber seal for the cargo door. The body seal is fine but there is no seal on the actual door. Most "D" seals on the like of eBay seem too wide on the base and not high enough. From what I've measured I'd need at least 25 mm to get a seal.
Anyone know where I can get some from? MM of course being the last resort..

There isn't a seal on the door, only on the body.

[Guest]

That's because I ripped it off and threw it out 😊

[spot01]

That's because I ripped it off and threw it out 😊

I'm confused?
Where exactly on the door was the seal?
Was it retained using clips or some other method?

[Roofchop]

Plenty of Pajeros in the wreckers....


Cheers
Dave

[Guest]

G'day mate, it's held on by some little white lugs that go through holes in the rubber. The seal, starting from the passenger side, goes from the bottom of the rear window, over the top of the door to about 3/4 the way down the driver's side of the door. I went to a wreckers that had one in perfect condition but he insisted on following me around like I was gonna theive stuff and then he destroyed it getting it off. So, back to square one..