Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > General Information > Electrical / Radios

Electrical / Radios Discussion of electrical systems and accessories.

Thread Tools Display Modes
Old 10-01-20
4x4Enthusiast 4x4Enthusiast is offline
Junior Member
Join Date: Dec 2014
Location: Brisbane North
Posts: 46
Default Tow Pro Elite Functionality

I have a tow pro elite installed and it worked fine. I did some work recently (installed light bar) and now I think there is something wring with the electronic brake system.

WITHOUT a trailer hitched to the vehicle I can't see any light showing at the controller button of the EBS that is installed in the dash next to the steering wheel. I saw the light when I was installing the on/off push button of the light bar next to the controller button of the EBS.

I tested for power of the EBS at the andersen plug at the back of the vehicle (where the trailer connect) and it is fine. I used one of those testers where the light comes on if the clamp is on earth and the pin is on the +ve.

Do I need to worry about anything?

Is the light of the controller button supposed to be showing when no trailer is connected. According to the user manual of the Tow Pro the auto calibration light is supposed to be visible even if no trailer is connected.

When installing the light bar I did disconnect the wire of the toe pro on the battery terminal. Should the EBS be reset in some way once the wires were disconnected?

Reply With Quote
Old 11-01-20
2bad4u's Avatar
2bad4u 2bad4u is offline
Senior Member
Join Date: Jun 2009
Location: Perth, Western Australia
Posts: 312

Once it is calibrated then you will only see a light with a trailer connected.

Also, if it is connected to your Anderson plug your wiring is incorrect. It should be to pin 5 on your trailer plug.
2012 NW DiD Activ
Reply With Quote
Old 11-01-20
Pajshomoneroguntero's Avatar
Pajshomoneroguntero Pajshomoneroguntero is offline
Valued Member
Join Date: Jul 2013
Location: Sydney
Posts: 1,348

As above. Press the towpro control button and it should give one blue pulse.
NX GLS MY16 Auto: MM Towbar | Spare Lift Kit | Cooper ST MAXX 265/65R17 | SPVi Module mk3.1 | Autosafe Half Cargo Barrier | Torque Pro App | Donaldson 3um 2ndry Fuel Filter | Diff Breathers | GME4500 UHF | Rhino Rack Pioneer Platform | Roley's Rear Bash Plate | Bushskinz Underbody Protection | Airtec Snorkel | Onboard Compressor | Awning | ARB Deluxe Bar | Lightbar | Sherpa4x4 Winch | Bushskinz Sidesteps | Masten TPMS

Build Thread
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Redarc Towpro Elite Theoffroaders Generation 4-2 Pajero 3 09-08-19 10:37 AM
Tow pro elite can bus issues Pittsy87 Generation 4-3 Pajero 14 31-07-19 08:01 PM
Redarc tow-pro elite FraserCoastBob Bolted on bits, factory and aftermarket accessories 2 18-07-18 05:45 PM
NW Pajero Redarc Tow Pro Elite Jasper26k Generation 4-3 Pajero 12 09-02-18 10:17 PM
TowPro Elite originalfunster Electrical / Radios 46 03-02-18 06:12 PM

All times are GMT +10. The time now is 03:02 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.