Hi,
was hoping to install a drawer and slide on the drivers side, but the rear door on the nx does not seem to be opening to a complete 90 degree angle. Seems the gas strut is not long enough and prevents the door from extending fully open. I measured and with drawer right against the drivers side wheel arch, it would start scraping the inside of the door and extend only halfway out before making contact with the door. Has anyone experience moving the bracket on the door, the one that holds the ballpoint end of strut, so the door opens up more?
was hoping to install a drawer and slide on the drivers side, but the rear door on the nx does not seem to be opening to a complete 90 degree angle. Seems the gas strut is not long enough and prevents the door from extending fully open. I measured and with drawer right against the drivers side wheel arch, it would start scraping the inside of the door and extend only halfway out before making contact with the door. Has anyone experience moving the bracket on the door, the one that holds the ballpoint end of strut, so the door opens up more?
Comment