Loss of power

[BruceandBobbi]

Oh dear.

If you have high boost or low boost code and limp mode and check engine light on switch engine of, wait 15 seconds and restart engine and bingo. Check engine light will still be on but NO limp mode.

FYI we have had P1299 and P1298 codes at the same time.

[Jerbear]

Loss of power ,Fixed

I drive pajero NT and occasionally experience engine management lite and Limp mode when towing my 2 ton van,mostly occurs going uphill but has happened on flat going 93Klms. Failed about 5 times in 100 k , have done 280K goes well without towing van.2 Mitsubishi dealers have, replaced EGR valve, gaskets and pipes, air flow sensor, boost sensor , swapped VGTSolenoid , and solenoid hose . Codes 1299 , 2413 , and fail with no code . Appreciate any ideas on this intermittent problem

AS reported above , with help of mitsubishi dealer in caloundra ,isolated the problem to a faulty "air flow meter" replaced sameand car now flys . best of luck ,stay safe