Hey guys, just got a snorkel for my pb what size hole saw do I need to get to do the main hole my instructions don’t say? Thanks
Below Nav Bar
Collapse
Snorkel fitting
Collapse
X
-
My intake pipe is a tight fit through the guard and I used a 4" (102mm) holesaw. Hardly a bee's whisker in it.
If you centre your holesaw arbor in the front mounting hole for the coolant overflow bottle then the intake pipe should be in the correct position. There's some flexibility in the right angled piece that attaches to the airbox which gives you some leeway.2012 PB Challenger LS Manual
Comment
-
-
IIRC I used a 114mm holesaw and it worked OK.Paul 2015 PC Challenger LS Auto - 2" Ultimate lift, Duraturn 265/70/17 A/Ts , catch can and resistor mod, Custom MCC Bullbar ,12000lb winch , Dual batteries ,Boo's Bash plates ,E-Drive throttle controller,Auto Mate, In car entertainment and more.
Comment
-
Matched content
Collapse
Comment