Originally posted by Ian Sharpe
View Post
Below Nav Bar
Collapse
Anyway to turn off traction control
Collapse
X
-
-
-
Originally posted by Busby View PostI have done the gray wire mod on my v77 2005 np v6 but no lights come on when I earth the wire, any ideas, cheers.
Comment
-
-
Originally posted by Busby View PostThanks for the reply Vlad, can it be done on the general 3,thanks.
Comment
-
-
Originally posted by NJV6 View PostToday I did this mod as per the instructions in the thread earlier, thanks slo78.
Cut the Grey wire
Start soldering
Re wrap loom and plug in and done.
I just put a simple two pole on/off switch next to the ASC switch - the wire I soldered to one side of the switch and the other side to a suitable bolt as an earth.
Switch off
Switch on
Hello
So by this method i can disactive the ATC while car running on am i right
Becuase i am thinking if u need to dis active ATC u need to switch car off befor using so to be sure mod run 100%
Comment
-
-
Originally posted by Rowaisan View Post
Hello
So by this method i can disactive the ATC while car running on am i right
Becuase i am thinking if u need to dis active ATC u need to switch car off befor using so to be sure mod run 100%
Comment
-
-
Originally posted by Rowaisan View Post
Hello
So by this method i can disactive the ATC while car running on am i right
Becuase i am thinking if u need to dis active ATC u need to switch car off befor using so to be sure mod run 100%1994 NJ SWB, 3.5 Manual, 285/75/16 Deegan 38s MT, 25mm body lift, Twin ARB air lockers, XD9000 winch, custom bar.
1991 NH LWB, 3.9 V8, trayback, solid front axle, Toyota hi mount winch
2011 NT GLX DiD, 3.2 Manual, 285/65/17 Falken Wildpeak AT3W, SPV EGR, Lovells SD rear, HD front, Bilsteins, Custom underbody protection, Safari Snorkel, JTig intercooler and loads of zip ties in the dash...
Comment
-
-
Originally posted by NJV6 View PostYes you can deactivate when moving simply by flicking the switch. Sometimes you need to turn the vehicle off to get it to go back on again. Sometimes not
Those without factory rear diff lock, you have to restart the engine for TC to be on again.
Comment
-
-
Originally posted by vladguan View PostASC can only be temporarily disabled until engine restarts. Cutting the grey wire and soldering an online switch will turn off TC instantly and turn TC on instantly if your car has factory rear diff lock. Otherwise, you have to restart the car for TC to come on again. You could also purchase my patch loom. Afew from Saudi Arabia and UAE have purchased it.
I allready member at Facebook and i saw the patch mod. for me our land mostly is sandy just wanna have TC off.
My vehicle pajero 2016 3.8 petrol gen4
Comment
-
-
Originally posted by Rowaisan View PostThanks Vald And NJV6
I allready member at Facebook and i saw the patch mod. for me our land mostly is sandy just wanna have TC off.
My vehicle pajero 2016 3.8 petrol gen4
Either way, the patch loom is available in either TC on or TC off or TC on/off combo. I also prefer to use a patch loom then to cut an important safety related wire.
Comment
-
-
I just did this - cutting the grey wire, putting a switch in but no lights come up on the dash. I've got a 2011 NT diesel with no dif lock. Am I doing something wrong?Pajero 2011 NT GLS DID Auto. 3" 304 stainless exhaust, dyno tuned (135awkw), EGR block, EGR cooler removed, provent catch can, custom intercooler
Comment
-
-
Originally posted by NT11Pajero View PostI just did this - cutting the grey wire, putting a switch in but no lights come up on the dash. I've got a 2011 NT diesel with no dif lock. Am I doing something wrong?
Comment
-
-
Originally posted by NT11Pajero View PostThe one in the plug shown earlier on in this thread. There's only 1 grey wire in that socket right? It lights up the led in my switch but there is no change to lights on the dash
Comment
-
Matched content
Collapse
Comment