If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
yep there is a member of our local club who has them - This User I believe is the one
1994 NJ 3.0 now with a 2000NL 3.5 engine and driveline, 2.5 catback, 32" MT Deegan 38's, 1" body lift, front diff drop with front tension rods indexed and cranked an 3", 3" on the rear coils
*** retired to the big wrecking yard in the sky***
1998 NL 3.5 blisterside, running a 6g75 (3.8) with M90 supercharger at 14psi, 305.70.16's on -44 rims 3.5" suspension lift, Custom Bull bar, winch install, custom front control arms, NJ GLS flares and some camping gear in the back
.
I purchased a set of the 1000mm / Prado drawers 12 months ago Just got around to modifying and fitting them cut the frame down by 40mm and 1 drawer by the same they are now a perfect fit you would have no problems fitting the 900mm drawers in the back of a 2nd gen Pajero the 900mm draws weren't available when I bought mine
NH shorty gls factory rear locker suspension seats 32" MTZ's 2" body lift 2" suspension lift ,4M41 conversion ,top mount IC,TJM Winch Bar 12000lb winch Stedi 120watt light bar plus more to come
Yep, they do fit, have a NJ ( son's ), we cut the plastic trim at the wheel arch where the drawers go, had to use a hammer and punch out the lower part of the inner gaurds about 50mm each side.
98 NL Pajero, 3.2 Common rail Diesel, Auto with some work.
I don't have any pics sorry, i helped a mate about 6 months ago, we had to shave a bit off the left hand drawer to fit inside the wheel arch, first we used that tubing from bunnings, the name escapes me now, to lift it off the floor 100mm or so, which then bought the amount of the adjusting to the left drawer back, it also gives you more space underneath to store as well, that was about it, the wings fitted pretty much perfect other than a couple of shaves with the electric plainer.
Someone mind posting pics of what they needed to do to make them fit and what they look like installed please?
I put up a post in do it yourself projects a few weeks back
NH shorty gls factory rear locker suspension seats 32" MTZ's 2" body lift 2" suspension lift ,4M41 conversion ,top mount IC,TJM Winch Bar 12000lb winch Stedi 120watt light bar plus more to come
Comment