Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > General Information > Body and Soul

Body and Soul Discussion about the chassis and body, paintwork, cabin fittings, air conditioning, etc.

Reply
 
Thread Tools Display Modes
  #1  
Old 07-08-18
Ian H Ian H is offline
Valued Member
 
Join Date: May 2015
Location: melbourne
Posts: 1,100
Default Drivers side front window issue

Not a big issue yet but for some reason, when I go to raise the drivers side window, it only goes up in small stages and stops. I lift the window button again and it goes up some more and stops again. It takes several goes to raise it to the closed position and it only started happening today. I did have a power cord running through it for my fridge last night and raised the window to the top but it didn't seem to like the cord jammed in there and came down again. Not all the way, just a few cm. I tried doing it a few times with the same result so maybe I've upset the electronics somehow.

Any clues ?
__________________
2015 NX GLS, MM Lockup Mate. Factory alloy bar, Peders Springs & EFS Shocks, dual batteries with Redarc DC/DC, LRA 58L tank, Safari snorkel, Boo's bash plates (full set), 17" steels with Toyo OPAT AT2's, Drifta drawers with slide, TPMS, Uniden UH8080S. Infinity caravan and a TVan Firetail.
Reply With Quote
  #2  
Old 07-08-18
sharkcaver's Avatar
sharkcaver sharkcaver is offline
"2000"+ Valued Contributor
 
Join Date: May 2009
Location: Perth
Posts: 5,874
Send a message via MSN to sharkcaver Send a message via Skype™ to sharkcaver
Default

I'd be more inclined to think somehow the window regulator or slides have been disturbed after squashing an extention cord in it, rather than an electrical issue. The window loaded up sideways and moved something in its mechanism. The up part way could be motor overload from a mechanism that now does not allow the glass to slide freely????

All the same, what a PITA.
__________________
Gone to a new home ...MY04 NP GLS Man Di-D, Look after her..


MY16 NX GLX5, Dobinson's HD springs + MRR shocks + Firestone airbags, 17" Toyo Opats, XXX bar, Dominator winch + IB500 relay, Full Bushskinz kit, Rhino track mount, 7" led spots, 23" light bar, SPV block, Ultragauge, Donaldson secondary filter, LRA 81L aux, 105AGM in rear + Projecta IDC25, 2 tier rear shelf + slide, ARB on board compressor, 2.5 x 3.0 awning

NX build


My Journeys
Reply With Quote
  #3  
Old 07-08-18
Ian H Ian H is offline
Valued Member
 
Join Date: May 2015
Location: melbourne
Posts: 1,100
Default

The glass seems to slide ok and the increments it comes up in seem to be equal, or roughly equal anyway. My concern is that we are in WA and travelling so if the window stops working, it could be a problem
__________________
2015 NX GLS, MM Lockup Mate. Factory alloy bar, Peders Springs & EFS Shocks, dual batteries with Redarc DC/DC, LRA 58L tank, Safari snorkel, Boo's bash plates (full set), 17" steels with Toyo OPAT AT2's, Drifta drawers with slide, TPMS, Uniden UH8080S. Infinity caravan and a TVan Firetail.
Reply With Quote
  #4  
Old 07-08-18
spot01 spot01 is offline
Valued Member
 
Join Date: Apr 2011
Location: Adelaide
Posts: 2,842
Default

I think the driver's window has an inbuilt safety feature to stop & reverse if it senses something (like a part of a person) caught in it. I think it is in the handbook?
I suspect you have inadvertently triggered this, but unsure why it hasn't simply reset.
__________________
Pajero NX MY16 GLS
Reply With Quote
  #5  
Old 07-08-18
Ian H Ian H is offline
Valued Member
 
Join Date: May 2015
Location: melbourne
Posts: 1,100
Default

That sounds plausible, it certainly stopped and reversed a few times when I had the cord in it.
__________________
2015 NX GLS, MM Lockup Mate. Factory alloy bar, Peders Springs & EFS Shocks, dual batteries with Redarc DC/DC, LRA 58L tank, Safari snorkel, Boo's bash plates (full set), 17" steels with Toyo OPAT AT2's, Drifta drawers with slide, TPMS, Uniden UH8080S. Infinity caravan and a TVan Firetail.
Reply With Quote
  #6  
Old 15-08-18
Ian H Ian H is offline
Valued Member
 
Join Date: May 2015
Location: melbourne
Posts: 1,100
Default

Just in case anyone else reads this, the issue has resolved itself and the window works fine. I had all the windows down to air out the car and happened to raise both front windows together. The drivers window went straight up with the passenger side and has been fine ever since.
__________________
2015 NX GLS, MM Lockup Mate. Factory alloy bar, Peders Springs & EFS Shocks, dual batteries with Redarc DC/DC, LRA 58L tank, Safari snorkel, Boo's bash plates (full set), 17" steels with Toyo OPAT AT2's, Drifta drawers with slide, TPMS, Uniden UH8080S. Infinity caravan and a TVan Firetail.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Drivers side, side mirror rattle jared01 Generation 4-3 Pajero 14 10-01-17 11:30 AM
Window TINT for front Drivers and Passangers Door rossyboys Generation 4-4 Pajero 7 29-03-16 05:15 PM
Drivers side window switches Steve_H Generation 3 Pajero 3 22-11-15 05:59 AM
Drivers side e/window convert to manual? t-rex1995 Generation 2 Pajero 4 28-11-12 06:56 PM
Mower vs. Drivers side window jawk Generation 4-1 Pajero 2 13-09-10 07:20 PM


All times are GMT +10. The time now is 12:37 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.