Hi Desi,
Recapping,
Auto can be selected to reverse and car will reverse but no dash "R" display on dash, no reversing lights and no reversing camera.
Is this correct?
If so then check you have 12vdc at the Red/Green wire on the downstream side of the plug that connects the inhibit switch to the wiring loom. Check this from the back of the plug by inserting a multimeter probe where the wires enter the plug, the negative probe to a good earth point, do this when the ignition is ON and the selector is in reverse, engine not running. Check both sides of the plug. If you have 12vdc on both sides this plug, trace the wiring loom back to the next plug and repeat the voltage checks.
This is a simple circuit.
OJ.
Recapping,
Auto can be selected to reverse and car will reverse but no dash "R" display on dash, no reversing lights and no reversing camera.
Is this correct?
If so then check you have 12vdc at the Red/Green wire on the downstream side of the plug that connects the inhibit switch to the wiring loom. Check this from the back of the plug by inserting a multimeter probe where the wires enter the plug, the negative probe to a good earth point, do this when the ignition is ON and the selector is in reverse, engine not running. Check both sides of the plug. If you have 12vdc on both sides this plug, trace the wiring loom back to the next plug and repeat the voltage checks.
This is a simple circuit.
OJ.
Comment