I went to wire up my el-cheapo lightbar at the weekend using the harness it came with.
All was going to plan till I tried to connect the headlamp adapter to the headlight. Unfortunately the male pins on the headlamp bulb are different to the female pins on the adapter. The other end seems to mate OK - just the connector (with the yellow rubber seal) doesn't fit.
Anyone have a solution?
I'd prefer not to cut into the loom if I can just change a plug on the adapter.
Do MM have a special connector size I can get hold of?
Any advice gratefully received.
Cheers
Sam
All was going to plan till I tried to connect the headlamp adapter to the headlight. Unfortunately the male pins on the headlamp bulb are different to the female pins on the adapter. The other end seems to mate OK - just the connector (with the yellow rubber seal) doesn't fit.
Anyone have a solution?
I'd prefer not to cut into the loom if I can just change a plug on the adapter.
Do MM have a special connector size I can get hold of?
Any advice gratefully received.
Cheers
Sam
Comment