I'm running a 4m41 in my NL and just purchased a chip tuning module, high volume SCV and pressure limiting blank. I was running a chip it chip and went quite well with the SCV and pressure limiter.
I've just installed the Chip Tuning module set on tune 9 and 20psi, the paj runs quite well and EGT's are still within a safe limit.
The kit came with a USB with additional tunes and an application to download these to the module,
but no USB drivers.
Their instructions supplied with the unit seem to be written for a different chip module version, Chip Tuning have since sent me the drivers, however, i cannot get their application to communicate with their module, i've tried XP pro and win 7 pro. Chip Tuning respond promptly to my emails, but offer no support.
I'm no stranger to computers, micro controllers or networking as these are a part of my daily job...
Has anyone had any experience with their 'My Tuner' application to load additional tunes ?
Cheers,
GM
I've just installed the Chip Tuning module set on tune 9 and 20psi, the paj runs quite well and EGT's are still within a safe limit.
The kit came with a USB with additional tunes and an application to download these to the module,
but no USB drivers.
Their instructions supplied with the unit seem to be written for a different chip module version, Chip Tuning have since sent me the drivers, however, i cannot get their application to communicate with their module, i've tried XP pro and win 7 pro. Chip Tuning respond promptly to my emails, but offer no support.
I'm no stranger to computers, micro controllers or networking as these are a part of my daily job...
Has anyone had any experience with their 'My Tuner' application to load additional tunes ?
Cheers,
GM
Comment