Hi everyone
Just purchased a PA challenger for cheap and despite giving it a good test drive, I didn't get to test out the 4wd system. Turns out it doesn't engage 😕
I've done a bit of googling but kind find my exact problem.
So with the ignition on, the 4wd light doesn't show (not sure if it's meant to)
I can engage 4h and 4 low but the light still doesn't come on. I don't think the front hubs are engaging, but the front drives haft starts turning if it's in 4h/4low.
Where would I start in trying to recitfy this. Since the front shaft is engaging fine, would manual hubs fix the problem?
Appreciate any help guys
Cheers
Just purchased a PA challenger for cheap and despite giving it a good test drive, I didn't get to test out the 4wd system. Turns out it doesn't engage 😕
I've done a bit of googling but kind find my exact problem.
So with the ignition on, the 4wd light doesn't show (not sure if it's meant to)
I can engage 4h and 4 low but the light still doesn't come on. I don't think the front hubs are engaging, but the front drives haft starts turning if it's in 4h/4low.
Where would I start in trying to recitfy this. Since the front shaft is engaging fine, would manual hubs fix the problem?
Appreciate any help guys
Cheers
Comment