Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Commercial Advertisers > Commercial Advertisers > Creighton's TJM

Creighton's TJM For all your 4wd accessories

Reply
 
Thread Tools Display Modes
  #11  
Old 23-01-14
Gus's Avatar
Gus Gus is offline
Administrator
 
Join Date: Mar 2008
Location: Traralgon. Vic
Posts: 4,078
Default

Hi Dogtor.. vet

(1) This will depend on your cargo barrier too! Mine is a tradesman 1.
All I did was put the frame together pushed back against the C/Barrier made up some brackets, (solid 1s), which extended to the child anchor points on the floor, (Behind 2nd row seats), also picked up the tie down points at rear, (Back of vehicle), as per instructions.

(2) No I had replaced the stock false floor you could retain & space as I have but you would need to cut access hole in it.

(3) As per instructions I mounted the stops to the draws themselves but instead of mounting their opposites to the side walls I tapped the holes & used 2 bolts with rubber washers. I can access these via the wing kits only need to be finger tight rubber holds them in place undoing allows the draws to slide out.

(4) The Child Anchor points are on the back edge, (Cargo Barrier end), you need to fit them prior to bolting the top on.

Gus.

Vehicle Sold
__________________
VX 200 Series 4.5L Twin Turbo-Diesel V8 Landcruiser HERE
NM Exceed 3.2 DID Auto Pajero. (SOLD) With a few Mods. HERE

How to get Forum Decals
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Rear draw system wazza1965 Generation 3 Pajero 10 26-10-13 03:49 PM
Draw system Bobster Generation 3 Pajero 2 03-08-11 10:53 AM
Draw System - Which one? Shayne Generation 2 Pajero 9 25-07-08 05:22 PM
Which draw system for NS? Sandgroper Bolted on bits, factory and aftermarket accessories 3 11-11-07 12:02 PM


All times are GMT +10. The time now is 07:46 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.