i have a nl 99 exceed manual petrol i need to replace my rear tail shaft but apparently there are 3 diff ones and measure 40mml diff between them i have a double sleeved sintrivical pivot joint at front of shaft and uni on rear of shaft was wondering if any one on here would know the exact measurements as besides taking out of car is the only way to get measurments of the shaft size i need
Below Nav Bar
Collapse
rear tail shaft
Collapse
X
-
differences are based on engine type and transmission type... so diesel manual.... petrol auto etc1994 NJ 3.0 now with a 2000NL 3.5 engine and driveline, 2.5 catback, 32" MT Deegan 38's, 1" body lift, front diff drop with front tension rods indexed and cranked an 3", 3" on the rear coils
*** retired to the big wrecking yard in the sky***
1998 NL 3.5 blisterside, running a 6g75 (3.8) with M90 supercharger at 14psi, 305.70.16's on -44 rims 3.5" suspension lift, Custom Bull bar, winch install, custom front control arms, NJ GLS flares and some camping gear in the back
.
-
-
but if you need a shorter than stock one...... https://www2.pajeroclub.com.au/forum...4&d=15292386971994 NJ 3.0 now with a 2000NL 3.5 engine and driveline, 2.5 catback, 32" MT Deegan 38's, 1" body lift, front diff drop with front tension rods indexed and cranked an 3", 3" on the rear coils
*** retired to the big wrecking yard in the sky***
1998 NL 3.5 blisterside, running a 6g75 (3.8) with M90 supercharger at 14psi, 305.70.16's on -44 rims 3.5" suspension lift, Custom Bull bar, winch install, custom front control arms, NJ GLS flares and some camping gear in the back
.
Comment
-
Matched content
Collapse
Comment