Thread: aftermarket ecu
View Single Post
  #21  
Old 08-06-18
Sketchypip Sketchypip is offline
Junior Member
 
Join Date: May 2018
Location: Brisbane
Posts: 17
Default

Quote:
Originally Posted by kalieracer View Post
Well a friend who does a GTO engine management built a custom ECU / ROM to run my truck. We added support for Mivec, VICS, Knock sensors, electric fan control, (ODB II for those who do not have it), wide band, forced induction that is all PNP in to the stock harness of the NL trucks. In my case my NK comes with the same motor as the NL (here in the states) only difference is the wiring harness is 4 plug vs 3 in the later trucks. You just install the ECU + wideband and tune it.

https://www.instagram.com/p/BiI9oKfD...-by=leosrawkus
Can you tell me what the trigger set up is for the NL 3.5? My 3.5 DOHC swapped SWB has a Haltech installed but the car isn't running at the moment due to the factory trigger setup not talking to the Haltech.

It was configured with an Evo 10 trigger setup because the Haltech doesn't have any available settings for the 6G74 in the drop down menus but clearly this isn't correct as we have no spark at all.
Reply With Quote