View Single Post
Old 22-03-19
dreamerman's Avatar
dreamerman dreamerman is offline
Senior Member
Join Date: Sep 2009
Location: Sydney
Posts: 384

Originally Posted by Seigried View Post
This is the what i do it for the factory fileter. Install the hoses. Prime run the engine at idle for a few minutes. Then prime again the button should remain hard to press.

I run it at idle because any air trapped in the system between the filter and the pump can potentially stall the engine. Allowing it to idle means it will stall in a save spot.
Thanks, do you mean while all hoses are installed then prime?
03/19 MY18 Pajero NX GLX Graphite | Tow Bar | Catch Can | Pre Fuel Filter | EGR Off Module | K&N Filter | Roof Racks | Torque Pro | Auto-Mate (pending install)
Reply With Quote