I had to change the brake pads on my pajero today , should have been an easy job ,except that the last time i had the tyres changed the tyre place used a rattle gun to tighten the wheel nuts
After attempting to remove the wheel nuts with my wheel wrench i had to beak out my rattle gun to undo those nuts , much to my displeasure.
What would happen in the middle of no where with wheel nuts so tight that they wont bugde.
What do others think about this situation?
After attempting to remove the wheel nuts with my wheel wrench i had to beak out my rattle gun to undo those nuts , much to my displeasure.
What would happen in the middle of no where with wheel nuts so tight that they wont bugde.
What do others think about this situation?
Comment