View Single Post
  #3  
Old 16-10-13
02-SR5 02-SR5 is offline
Valued Member
 
Join Date: Dec 2010
Location: Toowoomba
Posts: 1,670
Default

All I did.

Go to Bunnings and get some 15mm ply and get them to cut to the size of the rear floor.

If you cut it square, each corner will sit over the tie down points. Remove the tie down points and use a longer bolt and a big washer to hold the ply down.

I used a factory boot floor mat in the boot to sit over it.

I then purchased an ARB fridge slide and attached this to the ply base. The fridge sits in this.

Use a hole saw to cut a hole where the spare wheel winch is, and ensure the fridge slide doesn't sit over the hole.
__________________
MY17 Triton GLX Plus with Mitsubishi Canopy. Keeping it light and simple. 265/70/16 Nitto's, Bilstien shocks, Kings Springs front, Formula leafs rear, ECB nudge bar, Ligjtforce 170's, twin batteries and a ARB fridge.
Reply With Quote