Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 500
Search took 0.01 seconds.
Search: Posts Made By: RedSector
Forum: Generation 2 Pajero 29-02-16
Replies: 14
Views: 3,655
Posted By RedSector
Don't fill past the oil level plug whatever that...

Don't fill past the oil level plug whatever that takes (on flat level surface). To much is just as bad as not having any.
Forum: Generation 2 Pajero 29-02-16
Replies: 7
Views: 1,879
Posted By RedSector
The harmonic balancer is not connected (apart...

The harmonic balancer is not connected (apart from applied force of crank centre bolt) to the crankshaft gear or the crankshaft and to my knowledge is never an issue to remove the harmonic balancer...
Forum: Generation 2 Pajero 26-02-16
Replies: 7
Views: 1,879
Posted By RedSector
In my experience, the gear is soft highcarbon...

In my experience, the gear is soft highcarbon metal with a case hardening. Check the price of a new one and when or if all the above fails. Drill and tap 2 equally spaced m6 hole in crank gear. Use...
Forum: Generation 2 Pajero 23-02-16
Replies: 8
Views: 1,027
Posted By RedSector
The DOHC has two sensors for the temp of the...

The DOHC has two sensors for the temp of the water.

(1) provides the readout to the cluster console and is located at front top with single wire

(2) The second one is located, slightly further...
Forum: Generation 2 Pajero 23-02-16
Replies: 12
Views: 1,530
Posted By RedSector
Maybe bit late to this thread but if any of the...

Maybe bit late to this thread but if any of the above have not solved your problem. Suggest you check the pipe return outlets located on the front of each head, located under the cam belt. If they...
Forum: Generation 2 Pajero 26-06-15
Replies: 10
Views: 2,676
Posted By RedSector
Basically you are right. The revised (v1.3)...

Basically you are right. The revised (v1.3) lifters as the same as original but have an enlarged the hole to 3mm or 3.5mm (off memory- many moons ago now that I changed them over)



Generally...
Forum: Generation 2 Pajero 21-06-15
Replies: 17
Views: 3,077
Posted By RedSector
Idle is controlled by Engine management system...

Idle is controlled by Engine management system (ECU) using a stepping idle motor. The idle should be higher when cold and lower when hot. When working correctly, the information for this is gathered...
Forum: Generation 2 Pajero 21-06-15
Replies: 5
Views: 1,934
Posted By RedSector
Oh. my bad.... A injector pump leak front...

Oh. my bad....

A injector pump leak front seal or pump shaft seal could be the issue (not 100% sure but would be looking at it)
Forum: Generation 2 Pajero 15-06-15
Replies: 5
Views: 1,934
Posted By RedSector
Might be worth checking to see if a vacuum leak...

Might be worth checking to see if a vacuum leak is present before playing with the idle.
Forum: Generation 2 Pajero 14-06-15
Replies: 13
Views: 2,244
Posted By RedSector
If your going OEM then recommend buying it from...

If your going OEM then recommend buying it from USA not Australia as normally works out lot cheaper.

I buy from USA from
http://www.oemmitsubishiparts.com/

and it always works out cheaper than...
Forum: Generation 2 Pajero 12-06-15
Replies: 10
Views: 1,965
Posted By RedSector
Assuming that sensors and sensor plates check out...

Assuming that sensors and sensor plates check out ok (which they most likely do as there is not stored error code) and there are no error codes recorded then suggest trying replacement of the...
Forum: Generation 2 Pajero 25-05-15
Replies: 1
Views: 773
Posted By RedSector
http://www2.pajeroclub.com.au/forum/showthread.php...

http://www2.pajeroclub.com.au/forum/showthread.php?t=25792
Forum: Generation 2 Pajero 25-05-15
Replies: 14
Views: 2,375
Posted By RedSector
Would not bother trying to fix. Just pulled them...

Would not bother trying to fix. Just pulled them out completely, the effect of having them is like 5HP more in low power (below 3000 rpm).... turn off your Air conditioning gets more noticeable power...
Forum: Generation 2 Pajero 14-02-15
Replies: 7
Views: 5,260
Posted By RedSector
Good way to check :), the NJ is a V45w if 3.5dohc...

Good way to check :), the NJ is a V45w if 3.5dohc or an import which is v46w. There would be some NL models above v44w threshold of change, maybe I could have said this better some how... however...
Forum: Generation 2 Pajero 14-02-15
Replies: 7
Views: 5,260
Posted By RedSector
Your model is a V43W and my understanding is that...

Your model is a V43W and my understanding is that V44W upward was the first models with an engine immobiliser (please feel free to correct if you know that NL has them). Based on my understanding of...
Forum: Generation 2 Pajero 01-04-14
Replies: 31
Views: 5,391
Posted By RedSector
Yes you are correct, I guess I did not explain...

Yes you are correct, I guess I did not explain correctly because as mentioned the geometry does not change in this mod, my bad.

What I meant is the problem was there before you conducted the body...
Forum: Generation 2 Pajero 31-03-14
Replies: 20
Views: 2,986
Posted By RedSector
If you put the nut for the ball joint on...

If you put the nut for the ball joint on backwards and leave it raised a little (less than 1mm) then proceed to bash the crap out of the ball joint to get it to break contact, you wont damage the...
Forum: Generation 2 Pajero 31-03-14
Replies: 31
Views: 5,391
Posted By RedSector
IMO sounds like a uni joint vibration in either...

IMO sounds like a uni joint vibration in either the front or rear tail shaft (more likely to be the rear one but still possible to be front even without 4wd engaged).... You could just grease them...
Forum: Generation 2 Pajero 19-03-14
Replies: 15
Views: 2,748
Posted By RedSector
Just wondering why does it have fuel filter up...

Just wondering why does it have fuel filter up front ?

Also did you check the one under the vehicle (near the transmission) ?
Forum: Generation 2 Pajero 17-01-14
Replies: 15
Views: 3,608
Posted By RedSector
Nice write up. Like the negative issues you...

Nice write up. Like the negative issues you found, as I agree they are all so true of these dials IMO.
Forum: Generation 2 Pajero 13-01-14
Replies: 8
Views: 1,871
Posted By RedSector
These dials are crap IMO. Reason: They are not...

These dials are crap IMO. Reason: They are not transparent where needed.

Also your tacho not working is more likely to be a failure of signal generator or the wire in the engine bay IMO and not...
Forum: Generation 2 Pajero 13-01-14
Replies: 8
Views: 1,871
Posted By RedSector
Like I said I cant find the article but off...

Like I said I cant find the article but off memory it was using one of these products.
http://www.dakotadigital.com/index.cfm/page/ptype=results/Category_ID=287/home_id=59/mode=cat/cat287.htm
...
Forum: Generation 2 Pajero 13-01-14
Replies: 8
Views: 1,871
Posted By RedSector
I read a mod for this somewhere in a USA forum to...

I read a mod for this somewhere in a USA forum to get it working but I cant seem to find it. Something about changing the signal pulses to be accepted by the white tacho's. IDK for sure and I cant...
Forum: Generation 2 Pajero 13-01-14
Replies: 8
Views: 1,871
Posted By RedSector
NJ had white dash. look for 1995-96 6g74 Dash....

NJ had white dash. look for 1995-96 6g74 Dash. Mine is white.
Forum: Generation 2 Pajero 03-01-14
Replies: 9
Views: 2,160
Posted By RedSector
Bit hard to answer this definitively. They often...

Bit hard to answer this definitively. They often used different ones even on the same models. You need decent (uni removal set) tools to do be able to tackle the rear ones IMO.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT +10. The time now is 11:01 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.