Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 500
Search took 0.44 seconds.
Search: Posts Made By: old Jack
Forum: Bolted on bits, factory and aftermarket accessories 8 Hours Ago
Replies: 7
Views: 149
Posted By old Jack
So where does the fairlead bolt onto? OJ.

So where does the fairlead bolt onto?

OJ.
Forum: Bolted on bits, factory and aftermarket accessories 19 Hours Ago
Replies: 7
Views: 149
Posted By old Jack
Hi and welcome Steve, To my knowledge there...

Hi and welcome Steve,

To my knowledge there was not a factory winch mount availble in Australia.
Can you post some photos or a link that shows in detail the winch mount you have purchased?

OJ.
Forum: Generation 4-4 Pajero 20 Hours Ago
Replies: 8
Views: 972
Posted By old Jack
Before fitting a chip or doing an ECU tune, and...

Before fitting a chip or doing an ECU tune, and if you have a auto trans, then I would highly recommend fitting either a Lockup Mate or Auto Mate from MM4x4.
You will be surprised at hour much...
Forum: Generation 4-4 Pajero 2 Days Ago
Replies: 25
Views: 1,532
Posted By old Jack
In 2013 I saw a BT50 Dual Cab with a factory...

In 2013 I saw a BT50 Dual Cab with a factory alloy bullbar strapped to the roof rack after it failed on the Tanami Highway (Track). The mounts had partially failed and it had pivoted forward so the...
Forum: Generation 2 Pajero 2 Days Ago
Replies: 12
Views: 240
Posted By old Jack
Reducing you air inlet temperatures by changing...

Reducing you air inlet temperatures by changing the intercooler will only have a minor impact on the EGT's. I suspect money would be better spent looking at the cause of the high EGT's, like fuel...
Forum: Generation 4-4 Pajero 2 Days Ago
Replies: 25
Views: 1,532
Posted By old Jack
The upper brackets on a nudge bar do little more...

The upper brackets on a nudge bar do little more than stabilise the bar and reduce vibration, this is particularly important if the nudge bar is used to mount additional lighting.

The negative of...
Forum: Where the rubber hits the road. 2 Days Ago
Replies: 21
Views: 859
Posted By old Jack
Thanks Ian, Glad you are happy with the...

Thanks Ian,
Glad you are happy with the results.
In October, when you do the club weigh day if you could post the settler ride heights and accurate axle weights.

OJ.
Forum: The Bargain Store 3 Days Ago
Replies: 5
Views: 338
Posted By old Jack
All tyres get noisy as they wear, it is because...

All tyres get noisy as they wear, it is because the rubber age hardens and the tread wears unevenly, particularly on tyres with aggressive tread.


OJ.
Forum: Where the rubber hits the road. 3 Days Ago
Replies: 21
Views: 859
Posted By old Jack
Hi Ian, No problems with the assistance. ...

Hi Ian,

No problems with the assistance.

Can you please post your spring part numbers so I can check how close my calculations are in real life. This feedback provides validation of my...
Forum: Generation 4-4 Pajero 3 Days Ago
Replies: 4
Views: 304
Posted By old Jack
Is the problem the depth of the bullbar, the...

Is the problem the depth of the bullbar, the position of the predrilled mounting holes for lights and the back clearance between the the grille and the lights?

The mounting brackets may be...
Forum: Generation 4-3 Pajero 4 Days Ago
Replies: 9
Views: 529
Posted By old Jack
That's a good question! The National Code VSB14...

That's a good question!
The National Code VSB14 NCOP 11 specifically states wheel track reduction is not permitted on passenger vehicles but on MC (light off road vehicles) it states to contact the...
Forum: PB -PC Challenger 2009 - 2014 4 Days Ago
Replies: 3
Views: 303
Posted By old Jack
Try with the engine turned off, gearbox in...

Try with the engine turned off, gearbox in neutral.
It is a firm push down, across and forward.

OJ.
Forum: Generation 4-3 Pajero 4 Days Ago
Replies: 9
Views: 529
Posted By old Jack
I have read VSI8 twice and cannot find where it...

I have read VSI8 twice and cannot find where it states that the vehicle track can be decreased 25mm. What section is this statement in?

OJ.
Forum: PB -PC Challenger 2009 - 2014 5 Days Ago
Replies: 9
Views: 451
Posted By old Jack
Hi Richard, Any competent mechanic should be...

Hi Richard,

Any competent mechanic should be able to fit a suspension kit in 3 to 4 hours with reassembled front struts .Home mechanic can do this in about 5 to 6 hours.

Reusing your old...
Forum: Generation 4-3 Pajero 5 Days Ago
Replies: 9
Views: 529
Posted By old Jack
11mm inwards, this is a problem. 1. You are...

11mm inwards, this is a problem.
1. You are decreasing the vehicle track so this is illegal.
2. It will change the scrub radius of the steering and and this will effect the handling of the vehicle,...
Forum: PB -PC Challenger 2009 - 2014 6 Days Ago
Replies: 9
Views: 451
Posted By old Jack
No problem Richard, Unfortunately my Beadell...

No problem Richard,

Unfortunately my Beadell Tracks trip got postponed along with my CSR trip :(.
Combination of work and home commitments have meant extended trips are not possible for another...
Forum: Where the rubber hits the road. 6 Days Ago
Replies: 7
Views: 256
Posted By old Jack
OJ; Tyre's can comfortably run at up to 95C with...

OJ; Tyre's can comfortably run at up to 95C with out a problem but once they get to 100C and over then it is time to shed speed and or load.



Yes tyre temperature limits are elusive!

From...
Forum: Where the rubber hits the road. 6 Days Ago
Replies: 7
Views: 256
Posted By old Jack
The 4 psi rule is meant only for passenger...

The 4 psi rule is meant only for passenger construction tyre's on bitumen roads.
There is a 6psi guide that you can use for LT light truck construction tyre's when on bitumen only!
You measure the...
Forum: PB -PC Challenger 2009 - 2014 6 Days Ago
Replies: 1,715
Views: 348,480
Posted By old Jack
Have you tried pushing them inwards towards the...

Have you tried pushing them inwards towards the headlight then twisting?

OJ.
Forum: Bits and Pieces 6 Days Ago
Replies: 4
Views: 305
Posted By old Jack
Apparently so! ...

Apparently so!
https://jeep.fandom.com/wiki/Mitsubishi_Jeep

OJ.
Forum: PB -PC Challenger 2009 - 2014 6 Days Ago
Replies: 9
Views: 451
Posted By old Jack
Hi Richard, I have put your numbers into my...

Hi Richard,

I have put your numbers into my spring vs ride height calculator and I make the following comments.

Front Suspension.

1. Front Factory ride height is 542mm according to RVCS...
Forum: PB -PC Challenger 2009 - 2014 1 Week Ago
Replies: 1,715
Views: 348,480
Posted By old Jack
I have had a poor run with Osram Nightbreaker...

I have had a poor run with Osram Nightbreaker Umlimited which are meant to have a longer life than the Nightbreaker Laser, I only get 6 - 9 months out of a set but the low beams are used about 10...
Forum: Pajero Sport QE 2015 - 2019 1 Week Ago
Replies: 9
Views: 491
Posted By old Jack
Pajero Sport already has an ATF cooler fitted and...

Pajero Sport already has an ATF cooler fitted and the ECU program of the 8 speed trans is very similar to what MM4x4 have achieved with Auto Mate /Lockup Mate.

OJ.
Forum: Generation 4-4 Pajero 1 Week Ago
Replies: 5
Views: 341
Posted By old Jack
Have read of this thread. ...

Have read of this thread.
https://www2.pajeroclub.com.au/forum/showthread.php?t=65020

OJ.
Forum: Generation 3 Pajero 1 Week Ago
Replies: 11
Views: 464
Posted By old Jack
The Service Manual advises to apply insulation...

The Service Manual advises to apply insulation tape over the negative battery cable terminal connector after disconnecting the battery. The manual says to wait only 60 seconds but I would wait a bit...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT +10. The time now is 05:19 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.