Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 19 of 19
Search took 0.00 seconds.
Search: Posts Made By: tj90
Forum: Generation 3 Pajero 15-11-18
Replies: 3
Views: 951
Posted By tj90
Why not drill out your upstream cats with a drill...

Why not drill out your upstream cats with a drill and use o2 extenders to keep ecu happy. Replace the downstream one on main pipe.
Forum: Generation 3 Pajero 16-01-18
Replies: 0
Views: 535
Posted By tj90
radio antenna motor mystery wiring

my aerial or antenna motor (mr538122) has failed. The wiring to the motor has 2 pins - 12v and GND. The leads reverse polarity with the relay in the cabin. When 12v is on one leg, the motor retracts....
Forum: Generation 3 Pajero 01-10-17
Replies: 36
Views: 10,833
Posted By tj90
I finally replaced all 4 rear differential...

I finally replaced all 4 rear differential bushes. The two rears were definitely shot (new OEM rubber was stiff where the originals could move with little finger pressure. The front uppers were...
Forum: Generation 4-1 Pajero 07-08-17
Replies: 9
Views: 8,541
Posted By tj90
RGB: Thanks for the writeup and time to link...

RGB:

Thanks for the writeup and time to link the previous discussions. I actually used them to help me as well - I found that slo78u instructions to match my 2003 Montero perfectly.

I was...
Forum: Generation 3 Pajero 30-07-17
Replies: 36
Views: 10,833
Posted By tj90
Not sure how the nuts can loosen since there is a...

Not sure how the nuts can loosen since there is a cotter pin. Maybe wear? I checked my rear hub nuts which were torqued to >210NM. I removed them anyway and pounded the axle partly out of the hub...
Forum: Generation 3 Pajero 20-02-16
Replies: 0
Views: 605
Posted By tj90
Transmission issues at speed

I have a 2003 petrol with the V5A5 transmission (5ST option code). I *think* its a Jatco, but not sure. 300k km mileage and tranny has always been serviced with Diamond SPIII fluid flush and fills...
Forum: Generation 3 Pajero 22-11-15
Replies: 3
Views: 1,046
Posted By tj90
I was able to fix my windows. Thanks to...

I was able to fix my windows. Thanks to @easykill1978 I lifted up the panel using a plastic trim tool. Just like Steve, A slight lift allowed everything to work, Dropping it back down and it didnt...
Forum: Generation 3 Pajero 19-11-15
Replies: 3
Views: 1,046
Posted By tj90
Did you find anything when you opened the panel?...

Did you find anything when you opened the panel? I think I have the same exact problem. The other day, the family was driving when we encountered some smoke from another auto. All of us were trying...
Forum: Generation 3 Pajero 15-12-13
Replies: 12
Views: 2,613
Posted By tj90
Definitely not. I can put my hand on the...

Definitely not. I can put my hand on the accumulator and you can feel it knocking. THe piston inside must be sticking or something....
Forum: Generation 3 Pajero 13-12-13
Replies: 12
Views: 2,613
Posted By tj90
I took it to a dealer today and they told me that...

I took it to a dealer today and they told me that my 03 Paj was not part of recall. Actually I have a silver accumulator (4630A012) that apparently replaced the black bulb version (4630A011)....
Forum: Generation 3 Pajero 13-12-13
Replies: 12
Views: 2,613
Posted By tj90
Major breakthrough

Well I took off the heat shields and also checked the bearings for play. The bearings looked good (absolutely no play between suspension and spindle when pushing and pulling on it with my hands) so I...
Forum: Generation 3 Pajero 12-12-13
Replies: 12
Views: 2,613
Posted By tj90
Thanks for the suggestions. THe new pads both had...

Thanks for the suggestions. THe new pads both had plates riveted to the back of the pads. I am assuming that the rattle plates are integrated into the pads. I use plenty of brake grease on the back...
Forum: Generation 3 Pajero 12-12-13
Replies: 12
Views: 2,613
Posted By tj90
I checked both heat deflectors and they are not...

I checked both heat deflectors and they are not loose. I think Im going to pull the wheels and check front wheel bearing play next....
Forum: Generation 3 Pajero 11-12-13
Replies: 12
Views: 2,613
Posted By tj90
Help me diagnose scraping sound

All:

Hi - Ive been trying to track down an intermittent scraping sound coming from the front left side of the truck for a few weeks. The scrapping sound only lasts for a second or two. Its not...
Forum: Generation 3 Pajero 21-03-10
Replies: 14
Views: 14,115
Posted By tj90
Thanks for the help

I replaced the shocks on mine this weekend. The advice to take upper wishbone apart was a lifesaver. I scratched my head and skinned knuckles for an hour before I consulted this board on how to...
Forum: Generation 3 Pajero 05-03-10
Replies: 3
Views: 2,533
Posted By tj90
Thats funny - in the US, I cant find any...

Thats funny - in the US, I cant find any retailers selling bilsteins for this application. Maybe they exist, but I cant find them.

Who are the manufacturers of the aftermarket springs? Only ones...
Forum: Generation 3 Pajero 05-03-10
Replies: 3
Views: 2,533
Posted By tj90
replacement shock question - KYB and components

Have an 03 montero with 160kms and my shocks are toast. Im thinking of replacing with KYBs gas-a-just shocks. It is supposed to give a slightly higher performance ride than the standard KYB GR2...
Forum: Generation 3 Pajero 25-04-09
Replies: 21
Views: 8,904
Posted By tj90
I get a clunk too. Mostly from backing up and...

I get a clunk too. Mostly from backing up and hitting a small bump in the road etc. My mechanic isolated it down to front suspension bushes. He replaced and life was great for another 6 months. The...
Forum: Generation 3 Pajero 17-03-09
Replies: 52
Views: 17,846
Posted By tj90
Thanks

Excellent thread guys!! I have a 03 montero limited and went for light off-road session the other day. Got home and saw diff fluid in the driveway. One of my rear companion shafts had separated from...
Showing results 1 to 19 of 19

 
Forum Jump

All times are GMT +10. The time now is 11:52 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.