Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 273
Search took 0.01 seconds.
Search: Posts Made By: twisted32
Forum: Generation 3 Pajero 1 Day Ago
Replies: 9
Views: 187
Posted By twisted32
Adjust the lower spring perch with the HDs. ...

Adjust the lower spring perch with the HDs.

Pre load will not negatively effect the ride on a linear rate spring unless the coils bind on full compression. 10mm pre load won't be an issue.
...
Forum: Where the rubber hits the road. 1 Week Ago
Replies: 3
Views: 248
Posted By twisted32
These Falkens replaced Kumho MT51s. The MT51s had...

These Falkens replaced Kumho MT51s. The MT51s had a much harder life, and were replaced at 60k (30% tread remaining), and only had minor chipping, no missing tread blocks.

That is why I am so...
Forum: Where the rubber hits the road. 1 Week Ago
Replies: 3
Views: 248
Posted By twisted32
Well I decided to give the Falken MT01's (265/70...

Well I decided to give the Falken MT01's (265/70 R17)a try, on paper they stacked up, 3 ply sidewall, Japanese manufacturer (made in Thailand), limited but good online reviews and the price was...
Forum: Where the rubber hits the road. 1 Week Ago
Replies: 3
Views: 248
Posted By twisted32
Tyre Topic: Falken Wildpeak MT01

This Tyre Topic is for members to post about the Falken Wildpeak MT01. Post your thoughts on grip, noise, wear, airing down, or anything else you consider of interest to other members.

Falken...
Forum: Generation 4-3 Pajero 1 Week Ago
Replies: 7
Views: 382
Posted By twisted32
If you are in Sydney, highly recommend speaking...

If you are in Sydney, highly recommend speaking to Steve at Transformance Mechanical Engineering (TME) at Springwood. He has a level of attention to detail you don't come across very often. Even...
Forum: MM 4X4 10-01-20
Replies: 482
Views: 53,386
Posted By twisted32
Will it kill your gearbox, unlikely. I have been...

Will it kill your gearbox, unlikely. I have been running lock up mate, with more mods and power than yours. It does feel like a different vehicle with the torque converter locked up under load.
I do...
Forum: Generation 4-2 Pajero 10-01-20
Replies: 2
Views: 429
Posted By twisted32
Rear diff poly bushes will be the main...

Rear diff poly bushes will be the main contributing factor. Factory rubber masks the issue as it is part of the inherent design.
I have poly bushes and the clunk is much more evident on light...
Forum: Generation 3 Pajero 09-01-20
Replies: 7
Views: 446
Posted By twisted32
When good quality ( ie synthetic) and correct...

When good quality ( ie synthetic) and correct grade do not fix my gearbox issues, Redline lightweight shockproof always does. Better gear protection than trans fluid too...
Forum: Where the rubber hits the road. 30-11-19
Replies: 13
Views: 1,160
Posted By twisted32
Yokohama have recently released a 50/50 style AT...

Yokohama have recently released a 50/50 style AT (AT-X) also.
They have my interest, similar tread pattern as the Falken ATW's, but with a 3 ply sidewall.
Forum: Mechanical 29-11-19
Replies: 8
Views: 667
Posted By twisted32
MV Automatics at Blackwood always seem to get a...

MV Automatics at Blackwood always seem to get a good wrap. I know they have fixed a few VR4 autos...
Forum: Generation 4-1 Pajero 29-11-19
Replies: 36
Views: 2,485
Posted By twisted32
If said workshop replaced radiator, and did not...

If said workshop replaced radiator, and did not advise to install the fan shroud at this stage, I would be finding a new workshop....
Forum: Generation 4-3 Pajero 25-11-19
Replies: 22
Views: 1,964
Posted By twisted32
The fuel injector to injector connection is...

The fuel injector to injector connection is within the rocker cover. It is however a flared metal to metal fitting (no replaceableseal). The seals on the rocker cover seal oil from leaking from...
Forum: Generation 4-1 Pajero 25-11-19
Replies: 36
Views: 2,485
Posted By twisted32
Yeah use manual mode, and monitor trans temps as...

Yeah use manual mode, and monitor trans temps as well. I suspect you are 5th unlocked dumping lots of transmission heat into the coolant.

I use that climb for testing on mine on hot (40deg) days,...
Forum: Generation 4-1 Pajero 24-11-19
Replies: 36
Views: 2,485
Posted By twisted32
What was the auto temp when coolant hit 117deg? ...

What was the auto temp when coolant hit 117deg?

You say it's in 4th, are you in sport mode, or assuming 4th from rpm?
Forum: Generation 4-3 Pajero 23-11-19
Replies: 22
Views: 1,964
Posted By twisted32
There are no fuel seals to replace when doing...

There are no fuel seals to replace when doing valve clearances, only oil seals in the rocker cover.
The fuel pipes are flared fittings (metal on metal) and can leak into the sump if not sealed...
Forum: Generation 4-4 Pajero 21-11-19
Replies: 6
Views: 780
Posted By twisted32
The Aisin requires valve body modifications to...

The Aisin requires valve body modifications to lock up in 1st.
Point it at a long hill in 1st low, and watch the auto temp rise, showing it is not locked.
Forum: Forum Meets / Where to Go! 19-11-19
Replies: 25
Views: 1,820
Posted By twisted32
Have booked it in :beer[1]:

Have booked it in :beer[1]:
Forum: Where the rubber hits the road. 15-10-19
Replies: 7
Views: 985
Posted By twisted32
Because the listed volume is for a "dry fill". ...

Because the listed volume is for a "dry fill".
When you drain it on car, some oil is trapped in the front half of the transfer due to the design.
Forum: Mechanical 15-10-19
Replies: 21
Views: 2,351
Posted By twisted32
50k, more like 15k for non genuine rears...

50k, more like 15k for non genuine rears...
Forum: Generation 4-2 Pajero 07-08-19
Replies: 18
Views: 2,168
Posted By twisted32
I was pleased mine sealed yesterday without any...

I was pleased mine sealed yesterday without any leaks and engine lights...😉
Only second time in checked in 180k and almost spot on still...
Forum: Where the rubber hits the road. 03-08-19
Replies: 5
Views: 745
Posted By twisted32
In red above, I beg to differ :nana[1]:

In red above, I beg to differ :nana[1]:
Forum: Generation 4-2 Pajero 08-04-19
Replies: 8
Views: 861
Posted By twisted32
Mine was done, exhaust, then intercooler, then...

Mine was done, exhaust, then intercooler, then tune. The exhaust and intercooler both made a small difference to response and economy, but the tune makes the largest difference. That being said, do...
Forum: Generation 4-2 Pajero 07-04-19
Replies: 8
Views: 861
Posted By twisted32
Steve at TME in Springwood.

Steve at TME in Springwood.
Forum: Generation 4-2 Pajero 28-02-19
Replies: 26
Views: 4,416
Posted By twisted32
Thumbs up Ahh, yep that is what I meant nj🍻

Ahh, yep that is what I meant nj🍻
Forum: Generation 4-2 Pajero 27-02-19
Replies: 26
Views: 4,416
Posted By twisted32
Expect around 25-30% increase in power and torque...

Expect around 25-30% increase in power and torque everywhere from a quality remap.
This will put a lot of extra heat into the trans, so best to have the lock up kit too.
It definitely changes the...
Showing results 1 to 25 of 273

 
Forum Jump

All times are GMT +10. The time now is 06:51 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.