Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 172
Search took 0.01 seconds.
Search: Posts Made By: Wazzap
Forum: Generation 3 Pajero 20-03-19
Replies: 25
Views: 1,628
Posted By Wazzap
If you can do wiring yourself, buy a cheap car...

If you can do wiring yourself, buy a cheap car alarm from ebay and wire it in. I bought one for <$50 which gave me 2 remotes, plus of course the benefits of an alarm.
Forum: The Bargain Store 03-02-19
Replies: 13
Views: 1,177
Posted By Wazzap
Yeah for sure, they're not that expensive and a...

Yeah for sure, they're not that expensive and a shop/technician could get a set that would do basically any car they see, would also be quicker than setting the torque on a torque wrench (which is...
Forum: Generation 4-2 Pajero 03-02-19
Replies: 19
Views: 1,454
Posted By Wazzap
To answer your original question on is it easy -...

To answer your original question on is it easy - yes, it's dead simple. I've got a NM but don't think they've changed much especially with the mounting of the seats, but to remove the single seat all...
Forum: The Bargain Store 03-02-19
Replies: 13
Views: 1,177
Posted By Wazzap
One big benefit of the battery ones is you can...

One big benefit of the battery ones is you can chuck them in the car, so if you're ever out and need to change a wheel or something you can use the impact rather than a wheel brace. I've got a Ryobi...
Forum: Generation 3 Pajero 12-01-19
Replies: 7
Views: 625
Posted By Wazzap
Start with the easy things first - the problem...

Start with the easy things first - the problem occurred after you installed the new radio, so disconnect the new radio and see what if anything comes good. Unless you've gone for a radio of the same...
Forum: Body and Soul 03-11-18
Replies: 6
Views: 1,782
Posted By Wazzap
The metal check strap on the bottom of the door...

The metal check strap on the bottom of the door can lock the door open, so if a large gust of wind comes in it won't slam the door closed.
Forum: Wanted 28-09-18
Replies: 1
Views: 575
Posted By Wazzap
Check with Mitsubishi on the centre console...

Check with Mitsubishi on the centre console latch, they still had them (and cheap - likely less than a wrecker would sell it for) a couple of years back.
Forum: Bits and Pieces 21-09-18
Replies: 6
Views: 1,218
Posted By Wazzap
Given the small cost of a set of axle stands and...

Given the small cost of a set of axle stands and the high cost if they fail, I wouldn't recommend using these. Looks like there are no manufacturer/model markings on them, so they may even be a home...
Forum: Generation 3 Pajero 16-09-18
Replies: 5
Views: 639
Posted By Wazzap
Wires are in the drivers side kick panel, don't...

Wires are in the drivers side kick panel, don't recall off hand the wires for the indicators but the central locking is a negative trigger - wires are brown/red stripe (unlock) and light green/red...
Forum: Generation 3 Pajero 21-06-18
Replies: 2
Views: 713
Posted By Wazzap
I thought all Gen3s came with remote central,...

I thought all Gen3s came with remote central, though it's quite likely the remotes have been lost. Mine came with no remotes so I installed an alarm with a remote (cheaper than replacement factory...
Forum: Electrical / Radios 07-05-18
Replies: 2
Views: 693
Posted By Wazzap
Yes you can. I'd recommend wiring it to an...

Yes you can. I'd recommend wiring it to an auto-reset circuit breaker like this one ('https://www.jaycar.com.au/chassis-mount-autoreset-circuit-breaker-50a-12vdc/p/SF4106') close to the battery for...
Forum: Body and Soul 02-05-18
Replies: 4
Views: 1,276
Posted By Wazzap
You need to take the top cream panel off first,...

You need to take the top cream panel off first, so need to remove the grab handles then everything else is just pop clips - this is also held in by the seat belts but if you don't need to take the...
Forum: Body and Soul 28-04-18
Replies: 9
Views: 2,082
Posted By Wazzap
You wouldn't even need to fabricate one - just go...

You wouldn't even need to fabricate one - just go to a wreckers and get the brackets off a car there. The only thing you would really need to check is the thread of the bolt that goes through the...
Forum: Generation 3 Pajero 27-04-18
Replies: 2
Views: 697
Posted By Wazzap
I'd be interested to see someone do it, but when...

I'd be interested to see someone do it, but when I looked at this previously I put it in the too hard basket. The way that the steering wheel connects to the steering shaft is different between them...
Forum: Electrical / Radios 27-04-18
Replies: 4
Views: 762
Posted By Wazzap
Depending exactly how old it is (if it was around...

Depending exactly how old it is (if it was around the time of the change to 80 channel - late 2010 or so) you may be able to upgrade it to an 80 channel by following the instructions in this link:...
Forum: Bits and Pieces 17-04-18
Replies: 3
Views: 1,379
Posted By Wazzap
Not exactly what you're after, but have you...

Not exactly what you're after, but have you looked at OctoPi? It runs on a raspberry pi which is cheap as chips, can have a touch screen added to the PI as well as a camera so you can remotely...
Forum: Generation 3 Pajero 03-02-18
Replies: 27
Views: 2,454
Posted By Wazzap
3 leg oil filter tool is the way to go - but...

3 leg oil filter tool is the way to go - but rather than paying $40 at supercheap, buy one from ebay...
Forum: Generation 3 Pajero 20-01-18
Replies: 90
Views: 54,195
Posted By Wazzap
If you use Google Chrome there is an extension...

If you use Google Chrome there is an extension called Photobucket hotlink fix (https://chrome.google.com/webstore/detail/photobucket-hotlink-fix/kegnjbncdcliihbemealioapbifiaedg) that fixes/displays...
Forum: Body and Soul 20-01-18
Replies: 9
Views: 1,612
Posted By Wazzap
Figure out the thread of the bolt and get some...

Figure out the thread of the bolt and get some rivnuts/nutserts to match. They go in similar to rivets so you put it through the hole and use the rivnut tool (can DIY one out of a bolt, couple of...
Forum: Generation 3 Pajero 19-01-18
Replies: 27
Views: 2,454
Posted By Wazzap
You could get a drain valve from Fumoto or...

You could get a drain valve from Fumoto or similar to replace your drain plug, this way you just rotate the handle to drain or block, so could drain out as much as your container holds then block it...
Forum: Generation 3 Pajero 29-10-17
Replies: 9
Views: 911
Posted By Wazzap
If you can't heat shrink it (say it's a mid wire...

If you can't heat shrink it (say it's a mid wire splice that you just want to cut the insulation off but not actually cut the wire) you can also use self amalgamating tape - it's non sticky (will...
Forum: Generation 4-1 Pajero 26-10-17
Replies: 19
Views: 1,834
Posted By Wazzap
If you're going to get rid of it, chuck it up on...

If you're going to get rid of it, chuck it up on here for sale - mention the issues/work it needs done and price it appropriately and you'll quite likely get more from someone who is prepared to do...
Forum: Electrical / Radios 11-10-17
Replies: 2
Views: 669
Posted By Wazzap
That used to be the way to do it - the stereo...

That used to be the way to do it - the stereo would come with a harness that had labelled wires on the car end, so you would cut the factory harness off to wire the new one in. Some people still do...
Forum: Electrical / Radios 26-09-17
Replies: 7
Views: 1,297
Posted By Wazzap
I'll jump in and agree - have had a fairly...

I'll jump in and agree - have had a fairly annoying problem with my hardwired dash cam for the past couple of weeks - when I start the car in the morning the dash cam won't come on, but in the...
Forum: Bits and Pieces 26-09-17
Replies: 1
Views: 997
Posted By Wazzap
I'm surprised they've put this feature in without...

I'm surprised they've put this feature in without some additional protections - surely they could use the blind spot cameras to see if there is a vehicle approaching and block the door on that side...
Showing results 1 to 25 of 172

 
Forum Jump

All times are GMT +10. The time now is 06:39 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.