Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: erad
Forum: Pajero Sport QE 2015 - 2019 6 Hours Ago
Replies: 6
Views: 235
Posted By erad
Would you consider any of these faults dangerous?...

Would you consider any of these faults dangerous? As far as I can see, they are annoying for sure but not unsafe.
Forum: Generation 4-2 Pajero 8 Hours Ago
Replies: 28
Views: 1,145
Posted By erad
I believe that there is merit in using a chemical...

I believe that there is merit in using a chemical to try to kill off the fungus/algae/mould - whatever it is. You would be really pushed to properly clean it all out by scrubbing etc and it will tend...
Forum: Generation 3 Pajero 9 Hours Ago
Replies: 2
Views: 54
Posted By erad
You may possibly have the clutch not fully...

You may possibly have the clutch not fully disengaging as you push the pedal down. Possible causes for this are a sticky clutchplate on the input shaft or maybe a spongy hydraulic system. The latter...
Forum: Generation 2 Pajero 9 Hours Ago
Replies: 33
Views: 844
Posted By erad
Stu: If the beast is firing 5 or 6 tomes per rev,...

Stu: If the beast is firing 5 or 6 tomes per rev, you probably won't see the 'extra firing because it would be out of the range on the crankshaft pulley. But it would be worth trying. When I stuffed...
Forum: Generation 4-1 Pajero 1 Day Ago
Replies: 12
Views: 599
Posted By erad
I don't want to start another bunfight like once...

I don't want to start another bunfight like once before, but before you splash out your money, get an assurance from the supplier that the HNMII can do exactly what you want it to do. I have a HNMii...
Forum: Generation 3 Pajero 1 Day Ago
Replies: 9
Views: 245
Posted By erad
Have a look at the back face of the belt. There...

Have a look at the back face of the belt. There should be some labelling on the face eg the brand name and the model number etc. If that is still on the belt, it is relatively new. the back of the...
Forum: Generation 2 Pajero 1 Day Ago
Replies: 33
Views: 844
Posted By erad
I doubt that the tacho reading high would affect...

I doubt that the tacho reading high would affect the running of the engine, BUT, IF the engine is running at 600 R/min and the ECU thinks it is running at 3000 R/min, it is possible that you are...
Forum: Pajero Sport QE 2015 - 2019 1 Day Ago
Replies: 6
Views: 235
Posted By erad
Tnks for your replies. I'll pass these on to him...

Tnks for your replies. I'll pass these on to him when next I see him.
Forum: Generation 2 Pajero 1 Day Ago
Replies: 33
Views: 844
Posted By erad
My reading of your post is that the engine is...

My reading of your post is that the engine is idling at something like normal speed, but the tacho is showing 3000 R/min. Is that correct? If this is so, obviously the tacho or its driver is U/S.
...
Forum: Do It Yourself Projects 1 Day Ago
Replies: 6
Views: 165
Posted By erad
DiscoStu: You had better not make posts like your...

DiscoStu: You had better not make posts like your last one here, or I will have to go out and buy a new hat because my old one won't fit any more. I am pleased that the fan now works. The OP will...
Forum: Pajero Sport QE 2015 - 2019 1 Day Ago
Replies: 6
Views: 235
Posted By erad
2017 Pajero Sport - Any problem to look for?

A friend of mine has seen the light and bought a 2017 Pajero Sport. He thinks the beast is awesome. I must admit that I don't particularly like them (mainly because I cannot see out of it from the...
Forum: Generation 4-2 Pajero 1 Day Ago
Replies: 28
Views: 1,145
Posted By erad
If there is a fungus buildup in the tank, sadly I...

If there is a fungus buildup in the tank, sadly I think it will be on the crown of the tank as well as the walls. Now, apart from rolling the car over onto its roof, I cannot see any way of getting...
Forum: Generation 4-1 Pajero 2 Days Ago
Replies: 20
Views: 653
Posted By erad
When is is dried out a bit, give the DPF a decent...

When is is dried out a bit, give the DPF a decent thump and then rattle it. If you hear something loose inside, you may have some loose baffles etc inside.
Forum: Generation 3 Pajero 2 Days Ago
Replies: 14
Views: 778
Posted By erad
If you have a manual transmission, check the...

If you have a manual transmission, check the limit switch on the clutch pedal as well.
Forum: Generation 4-1 Pajero 2 Days Ago
Replies: 20
Views: 653
Posted By erad
Sounds as if it is the DPF all cagged up. Can you...

Sounds as if it is the DPF all cagged up. Can you try soaking some solvent or a few days and then trying to wash it out? A replacement DPF will not be chap.
Forum: Generation 4-2 Pajero 3 Days Ago
Replies: 28
Views: 1,145
Posted By erad
The scum covering the intake filter is algae....

The scum covering the intake filter is algae. Probably the best way to do the job properly is to remove the tank and thoroughly wash it out with bleach etc, dry it all and then reinstall it. From...
Forum: Do It Yourself Projects 4 Days Ago
Replies: 6
Views: 165
Posted By erad
The resistor bank in the fan speed control...

The resistor bank in the fan speed control controls the voltage being applied to the cabin fan. At setting 4, the resistors have been bypassed, so the fan is getting the full 12 V applied to it. It...
Forum: General Info 4 Days Ago
Replies: 10
Views: 595
Posted By erad
Responding to the last two posters, the...

Responding to the last two posters, the Moomba-Sydney gas pipeline was one of the first major pipelines done in Australia. It is 760 mm diameter, which is quite large as gas pipelines go. However,...
Forum: General Info 4 Days Ago
Replies: 10
Views: 595
Posted By erad
Re laying gas pipelines across Oz to get gas to...

Re laying gas pipelines across Oz to get gas to the East, this is a utopian ideal. Hopefully it will happen one day, but don't hold your breath. Laying pipelines is expensive and temporarily does...
Forum: Generation 4-1 Pajero 4 Days Ago
Replies: 20
Views: 653
Posted By erad
You may still have an obstruction in the exhaust...

You may still have an obstruction in the exhaust (a bit unlikely, but possible). You could have a flap of corroded material in the muffler which gets moved to a position where it blocks the gas flow...
Forum: Generation 2 Pajero 5 Days Ago
Replies: 33
Views: 844
Posted By erad
Is it just the tacho jumping to 3000 r/min or is...

Is it just the tacho jumping to 3000 r/min or is the engine revving that high as well? I doubt that the Crank Angle Sensor would cause this sort of action, but, sorry, it has gone beyond my...
Forum: Generation 4-1 Pajero 5 Days Ago
Replies: 20
Views: 653
Posted By erad
I suggest that you wrap some wire into the joint...

I suggest that you wrap some wire into the joint and then push the muffler putty into the ie the wire is to reinforce the putty.
Forum: Mitsubishi News 5 Days Ago
Replies: 12
Views: 690
Posted By erad
I just spent (wasted) 13 minutes (plus ads)...

I just spent (wasted) 13 minutes (plus ads) watching this. As usual, the language is gutter stuff, but in this case I think he has a point. The 10 year warranty really means nothing in my book. If...
Forum: Generation 4-4 Pajero 5 Days Ago
Replies: 15
Views: 909
Posted By erad
Ozzz wrote, in part "Keep in mind not everyone is...

Ozzz wrote, in part "Keep in mind not everyone is broke"

Not yet, but when the brown stuff hits the whirring blades, there is going to be quite a few people who really come down to earth with a...
Forum: General Info 6 Days Ago
Replies: 10
Views: 595
Posted By erad
Low fuel warning

The following is a copy of an article in the October edition of Engineers Australia - the journal of the Institution of Engineers Australia. It is worth reading and I suggest that you could pursue...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT +10. The time now is 03:00 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.