Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: nj swb
Forum: Generation 4-3 Pajero 1 Hour Ago
Replies: 45
Views: 952
Posted By nj swb
There's nothing wrong with your boost sensor. ...

There's nothing wrong with your boost sensor. The "calculated boost" is using units that barely register on the vertical scale of the graph - as I posted earlier, it is attempting to show 0 - 0.5...
Forum: Generation 4-3 Pajero 3 Hours Ago
Replies: 45
Views: 952
Posted By nj swb
OK, I can't explain everything that's going on...

OK, I can't explain everything that's going on there, but I think the "zero boost" was a Furphy. The green MAP signal clearly shows significant amounts of boost that isn't reflected in the red...
Forum: Generation 4-2 Pajero 3 Hours Ago
Replies: 2
Views: 53
Posted By nj swb
That may not be helping. You state you were...

That may not be helping.

You state you were holding in 4th to keep the TC locked, which is a good thing to do - as long as you're travelling fast enough for the TC to lock in 4th. What sort of...
Forum: Generation 4-3 Pajero 3 Hours Ago
Replies: 45
Views: 952
Posted By nj swb
Excellent! Now watch the display as you...

Excellent!

Now watch the display as you repeat the engine stall trick - see if it registers a large negative pressure in the manifold.
Forum: Generation 4-3 Pajero 3 Hours Ago
Replies: 45
Views: 952
Posted By nj swb
If you can stall the engine by blocking the...

If you can stall the engine by blocking the intake there is not a major leak in the intercooler or hoses.

It is possible that, under pressure, a crack or gap might open up, but such pressure would...
Forum: Generation 4-3 Pajero 3 Hours Ago
Replies: 45
Views: 952
Posted By nj swb
The "sensor thing" with the wires is a solenoid...

The "sensor thing" with the wires is a solenoid valve, the first device is a vacuum diaphragm. When the solenoid is off the hose from the vacuum diaphragm is venting to atmosphere, so it's no...
Forum: Generation 2 Pajero 6 Hours Ago
Replies: 310
Views: 16,520
Posted By nj swb
If I've understood this correctly, some NLs...

If I've understood this correctly, some NLs towards the end of the model run have airbags that are not affected by this recall. If one can be found, can one of these be installed in an earlier NL...
Forum: Generation 4-3 Pajero 20 Hours Ago
Replies: 45
Views: 952
Posted By nj swb
There could be a problem with the intercooler or...

There could be a problem with the intercooler or piping resulting in loss of boost. But for air to be escaping requires a pressure differential - for air to be pushed out the pressure in the piping...
Forum: Generation 4-4 Pajero 21 Hours Ago
Replies: 10
Views: 379
Posted By nj swb
Tapered wheel nuts will centre the wheel as they...

Tapered wheel nuts will centre the wheel as they are tightened. The non - tapered "sleeved" nuts (for want of a better term:dunno[1]:) used by our factory wheels don't centre the rim as they tighten...
Forum: Generation 3 Pajero 23 Hours Ago
Replies: 9
Views: 180
Posted By nj swb
These solutions from Lovells don't affect the...

These solutions from Lovells don't affect the load on the spring.

The load on the spring comes from the weight on the wheel. The weight is what causes the spring to compress. If the spring is...
Forum: General Info 23 Hours Ago
Replies: 2
Views: 80
Posted By nj swb
I don't normally have any trouble with my VIN at...

I don't normally have any trouble with my VIN at partsouq, but it's not working for me at the moment.

For the record, my VIN has never worked at Amayama. :dunno[1]:
Forum: Generation 2 Pajero 23 Hours Ago
Replies: 310
Views: 16,520
Posted By nj swb
I typically work in industrial environments,...

I typically work in industrial environments, designing & installing custom one-off solutions to meet specific requirements, so I've only really looked at the WHS laws and my obligations there....
Forum: Generation 2 Pajero 1 Day Ago
Replies: 310
Views: 16,520
Posted By nj swb
It's our WHS laws. In 2012 Australia...

It's our WHS laws.

In 2012 Australia introduced a significant overhaul to WHS laws, and essentially the same laws have been implemented in all states.

Under our WHS laws all designers,...
Forum: Pajero Sport QE 2015 - 2019 1 Day Ago
Replies: 27
Views: 1,402
Posted By nj swb
100 degrees is only significant because it's the...

100 degrees is only significant because it's the boiling point of water - by definition.

Modern coolants boil significantly above 100 degrees, and oils can cope with higher temperatures again.
...
Forum: Generation 2 Pajero 1 Day Ago
Replies: 310
Views: 16,520
Posted By nj swb
Last I heard (going back a few years now) the...

Last I heard (going back a few years now) the Land of the Free don't have roadworthy rules, because it would discriminate against the poor.

Drive it, or don't drive it.

Disable the airbags, or...
Forum: Pajero Sport QE 2015 - 2019 1 Day Ago
Replies: 27
Views: 1,402
Posted By nj swb
Were you using sports mode to choose the gears...

Were you using sports mode to choose the gears yourself, or driving in D?

Mitsubishi aren't renowned for intelligent programming of the automatic transmissions. Driving in D tends to hang on to...
Forum: Generation 4-2 Pajero 1 Day Ago
Replies: 18
Views: 6,648
Posted By nj swb
Yes, your NT definitely has a separate ECU for...

Yes, your NT definitely has a separate ECU for the transfer. That diagram is for a 2009 model, which is the year of my NT.
Forum: Generation 2 Pajero 2 Days Ago
Replies: 310
Views: 16,520
Posted By nj swb
Of course they are. What do you expect them to...

Of course they are. What do you expect them to do? :confused:

Problem with parts that risks death.

They can't replace the parts. The only other option is to eliminate the risk by not driving...
Forum: Generation 4-2 Pajero 2 Days Ago
Replies: 18
Views: 6,648
Posted By nj swb
The switch doesn't power the compressor directly....

The switch doesn't power the compressor directly. The switch signals the transfer ECU to engage the diff lock, which will then make its own decisions on whether or not to actually do it. Have a...
Forum: Generation 4-3 Pajero 2 Days Ago
Replies: 45
Views: 952
Posted By nj swb
P0106 is a problem with the manifold pressure...

P0106 is a problem with the manifold pressure sensor.
Forum: Generation 3 Pajero 2 Days Ago
Replies: 72
Views: 1,819
Posted By nj swb
Could the smooth / knock be something to do with...

Could the smooth / knock be something to do with the glow plugs? Glowing for a set time on start, then turning off?

Try jumping power direct to the glow plugs supply rail, see if that makes a...
Forum: Generation 4-3 Pajero 3 Days Ago
Replies: 45
Views: 952
Posted By nj swb
If it was a crack or split between turbo and...

If it was a crack or split between turbo and intake then some positive manifold pressure would still register.

No turbo sound and zero boost pressure sounds to me more like a sensor problem. ECU...
Forum: Pajero Sport QE 2015 - 2019 3 Days Ago
Replies: 10
Views: 1,884
Posted By nj swb
It's good to find somebody who actually knows all...

It's good to find somebody who actually knows all of their numbers, and I agree that you're well within the towing capabilities of your PS. :clap2[1]:



Because I'm an engineer I can't help...
Forum: Generation 4-3 Pajero 4 Days Ago
Replies: 45
Views: 952
Posted By nj swb
I use torque pro with an OBDLINK MX Bluetooth...

I use torque pro with an OBDLINK MX Bluetooth adaptor.

I like torque pro for the huge amount of information I can get on one screen, but it was a good solution for me because I already had a...
Forum: Generation 2 Pajero 4 Days Ago
Replies: 10
Views: 166
Posted By nj swb
To the best of my knowledge, vehicle modification...

To the best of my knowledge, vehicle modification laws in all states require at least 2 thirds of factory travel be retained, in both directions. So if the stock gap was 18mm, you should have at...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT +10. The time now is 03:57 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.