Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 423
Search took 0.01 seconds.
Search: Posts Made By: zacc
Forum: Generation 3 Pajero 16-10-18
Replies: 5
Views: 347
Posted By zacc
This is the rear of the motor not front , i was...

This is the rear of the motor not front , i was hoping to undo the 2 bolts put some sealer on it and put back on . The only thing i am concerned about is how the cam angle sensor gets it reading is...
Forum: Generation 3 Pajero 15-10-18
Replies: 5
Views: 347
Posted By zacc
So it is a easy fix , remove the 2 bolts pull the...

So it is a easy fix , remove the 2 bolts pull the cap out then replace when seal is replace ?
Forum: Generation 3 Pajero 15-10-18
Replies: 5
Views: 347
Posted By zacc
Cam angle sensor

Hi all had a look at were i have an oil leak it is were the cam angle sensor is , it is not leaking from the sensor o ring but from the part that bolts to the head . This is on a nm 3.5 ltr , is...
Forum: Generation 3 Pajero 08-10-18
Replies: 15
Views: 914
Posted By zacc
Just an update , disconnected my batterie on the...

Just an update , disconnected my batterie on the weekend when reconnected no need for radio code . Thanks for the advice .
Forum: Generation 3 Pajero 05-10-18
Replies: 3
Views: 428
Posted By zacc
Procedure after battery disconnect on nm 3.5

Hi all will be disconnecting my batterie tommorrow and would like to know the procedure on what to do on the first start , i seem to recall taking the engine up to 2000rpm and let it do the rest . Is...
Forum: Generation 3 Pajero 02-10-18
Replies: 4
Views: 321
Posted By zacc
Thanks but can not make it out .

Thanks but can not make it out .
Forum: Generation 3 Pajero 01-10-18
Replies: 1
Views: 255
Posted By zacc
1996 nudge bar fit nm ?

Hi will a nudge bar off a 1996 pajero bolt onto a nm pajero ?
Forum: Generation 3 Pajero 01-10-18
Replies: 4
Views: 321
Posted By zacc
Nm o2 signal wire at ecu

Howdy can some one tell me the o2 signal wire colour at the ecu as i want to check my o2 readings ? Thanks in advanced .
Forum: Generation 3 Pajero 01-10-18
Replies: 2
Views: 257
Posted By zacc
Cheers Billy500 , tried it today worked as you...

Cheers Billy500 , tried it today worked as you said .
Forum: Generation 3 Pajero 30-09-18
Replies: 2
Views: 257
Posted By zacc
Nm gls fog lights

Hi all i have a 2000 nm gls , on the dash i have the factory switch to turn on the fog lights that are suppose to be in the bumper and a little light shows in the dash once pushed . My pajero does...
Forum: Generation 3 Pajero 23-09-18
Replies: 5
Views: 509
Posted By zacc
All good now , yeh was a painfull episode.

All good now , yeh was a painfull episode.
Forum: Generation 3 Pajero 23-09-18
Replies: 5
Views: 509
Posted By zacc
Tried puting alarm in today could see the wires...

Tried puting alarm in today could see the wires coming out of theetacs but can not access them , any help ?
Forum: Generation 3 Pajero 17-09-18
Replies: 2
Views: 336
Posted By zacc
Cheers for that .

Cheers for that .
Forum: Generation 3 Pajero 17-09-18
Replies: 2
Views: 336
Posted By zacc
Nm 3.5 temperature signal

Yet another question , does the signal from the temperature guage influence the mixture of fuel ? When cold puts more fuel in as it heats up puts less fuel in , the reason i am asking is because the...
Forum: Generation 3 Pajero 15-09-18
Replies: 15
Views: 914
Posted By zacc
Tried a dealer near me gave them the vin and came...

Tried a dealer near me gave them the vin and came up as error , they wanted me to bring it in they would take radio out get serial number and contact mitsubishi australia plus cost $75.00 .
I rang...
Forum: Generation 3 Pajero 15-09-18
Replies: 2
Views: 276
Posted By zacc
Thanks for tha but nine seems to have 2 bolts .

Thanks for tha but nine seems to have 2 bolts .
Forum: Generation 3 Pajero 15-09-18
Replies: 15
Views: 914
Posted By zacc
So if mitsubishi australia dont have the code how...

So if mitsubishi australia dont have the code how do i source it ?
Forum: Generation 3 Pajero 14-09-18
Replies: 2
Views: 276
Posted By zacc
part at the rear cam shaft .

Howdy all , i have the 2000 nm 3.5 gls pajero . Today i was looking for an oil leak it looks like it is coming from the rear of the head on the passengers side at a part that is were the rear cam...
Forum: Generation 3 Pajero 14-09-18
Replies: 15
Views: 914
Posted By zacc
cheers thanks for that.

cheers thanks for that.
Forum: Generation 3 Pajero 14-09-18
Replies: 15
Views: 914
Posted By zacc
Radio code

Hi all i have a 2000 nm pajero i just purchased , i thought i would try get the radio code in case i need it further down the track . I contacted mitubishi australi gave them the vin and the radio...
Forum: Generation 3 Pajero 13-09-18
Replies: 5
Views: 509
Posted By zacc
Any help would be great.

Any help would be great.
Forum: Generation 3 Pajero 12-09-18
Replies: 5
Views: 509
Posted By zacc
After market alarm

Hi all i am finaly back after years of absence , just bought a 2000 nm gls and want to put an after market alarm in i did do this on my exceed i had but that was many moons ago and i just can not...
Forum: Generation 4-3 Pajero 30-09-13
Replies: 3
Views: 1,309
Posted By zacc
nw rust

Just a quick question , do the NW suffer the same rust issues as the NT ? Thanks
Forum: Generation 3 Pajero 28-09-13
Replies: 2
Views: 870
Posted By zacc
nm 3.5 thermostat opening

Can any one tell me what distance the thermostat should open when at temperature , mine is 9mm when fully opened . Thanks
Forum: Generation 3 Pajero 28-09-13
Replies: 4
Views: 1,109
Posted By zacc
Thanks for that one .

Thanks for that one .
Showing results 1 to 25 of 423

 
Forum Jump

All times are GMT +10. The time now is 12:12 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.