Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: erad
Forum: Generation 4-1 Pajero 1 Day Ago
Replies: 20
Views: 1,039
Posted By erad
Back here in Oz (and probably the rest of the...

Back here in Oz (and probably the rest of the world), there is a lot pf media coverage about the 50th anniversary of the moon landing. To loosely quote Mission control after they landed, "There's...
Forum: Generation 4-2 Pajero 2 Days Ago
Replies: 13
Views: 2,898
Posted By erad
dabela1972: Great coverage of the job. I hope...

dabela1972: Great coverage of the job. I hope that I don't have to do it myself, but if I do, I now have your youtube addresses recorded. I was surprised that you could get the old hub out without a...
Forum: Generation 3 Pajero 2 Days Ago
Replies: 15
Views: 562
Posted By erad
Can an alternator still charge AND drain the...

Can an alternator still charge AND drain the power when the vehicle is off? Diodes? Regulator?

Yes - if you have one diode stuffed out of the six, it is possible that the other 5 will still pump...
Forum: Electrical / Radios 3 Days Ago
Replies: 11
Views: 382
Posted By erad
The pressure switch is supposed to operate for...

The pressure switch is supposed to operate for low pressure or high pressure. At this time of the year, you are not likely to have high pressure in the gas system, but you could have low pressure....
Forum: Electrical / Radios 3 Days Ago
Replies: 11
Views: 382
Posted By erad
How did you test the pressure switch? The...

How did you test the pressure switch? The contacts should be closed if the compressor clutch is to operate, is the resistance across the switch terminals should be zero.
Forum: Electrical / Radios 5 Days Ago
Replies: 11
Views: 382
Posted By erad
I don't know about the later model Pajeros, but...

I don't know about the later model Pajeros, but the earlier ones used to require the cabin fan to be running before the A/C compressor would be powered up. I imagine this is still the case. Sometimes...
Forum: Generation 4-4 Pajero 5 Days Ago
Replies: 4
Views: 414
Posted By erad
The DFRs are LED type. Failure of them is...

The DFRs are LED type. Failure of them is unlikely. Your problem is probably more a fuse blown or a wire fallen off (if you have a bullbar), or a bad earth.
Forum: Generation 3 Pajero 5 Days Ago
Replies: 4
Views: 211
Posted By erad
Maybe a piece of crud had dropped down into the...

Maybe a piece of crud had dropped down into the fan cage and blocked it. Eventually it either moved or rotted away and now the fan is free?
Forum: Mechanical 1 Week Ago
Replies: 5
Views: 304
Posted By erad
Since no-one has come back at you with this, I'll...

Since no-one has come back at you with this, I'll have a go. You say "Torque Converter Clutch Pressure Control Solenoid Control Circuit Low"

The fact that you can clear the code and then drive for...
Forum: Generation 4-2 Pajero 1 Week Ago
Replies: 10
Views: 430
Posted By erad
NO! NM and NP models have different headlights,...

NO! NM and NP models have different headlights, so they require different bullbars. Anything from NS onwards will fit up the the NX, except that the NX has Daytime Running Lights, which require some...
Forum: Generation 4-2 Pajero 1 Week Ago
Replies: 10
Views: 430
Posted By erad
That would be "Will a bar form an NS model fit a...

That would be "Will a bar form an NS model fit a NT model?" Yes - it should. I fitted a genuine Mitsubishi non-winch bar branded for a NS model to my NW Pajero, no problems.
Forum: Camping /Caravan Parks/ Campers 1 Week Ago
Replies: 10
Views: 316
Posted By erad
Even going to the Cape the dust entry is very...

Even going to the Cape the dust entry is very tolerable

You are obviously not married to my wife. OCD would not describe her. But she loves getting out and about with our caravan, so there are...
Forum: Generation 4-3 Pajero 1 Week Ago
Replies: 7
Views: 567
Posted By erad
There seems to be a lot of work associated with...

There seems to be a lot of work associated with changing coolant. People seem to want to flush the whole system until they have pure water, then put in new coolant. I can see the reason for doing...
Forum: Generation 4-1 Pajero 1 Week Ago
Replies: 2
Views: 164
Posted By erad
I don't know about an Ironman bar, but I bought a...

I don't know about an Ironman bar, but I bought a genuine Mitsubishi NS bar (non winch) for my MY13 NW and fitted it myself. It went on OK with no major dramas. I had to drill the chassis to fit one...
Forum: Generation 2 Pajero 1 Week Ago
Replies: 5
Views: 313
Posted By erad
Somewhere in the fast fading memory of mine, I...

Somewhere in the fast fading memory of mine, I recall that there were problems with the 4M40 heads cracking. Maybe your head has a fine crack somewhere? I know it was a new head, but not everything...
Forum: Camping /Caravan Parks/ Campers 1 Week Ago
Replies: 31
Views: 552
Posted By erad
A ridiculous situation and the sooner we get...

A ridiculous situation and the sooner we get national, binding laws the better.

Sadly,i it ain't gonna happen. Oh that it would, but that is too much to expect.
Forum: Camping /Caravan Parks/ Campers 1 Week Ago
Replies: 10
Views: 316
Posted By erad
Depending on the relative heights of the camper...

Depending on the relative heights of the camper and the tug, the best place would be the roof. That is where manufacturers install the scupper vents. The worst place would be at the rear, because...
Forum: Generation 3 Pajero 1 Week Ago
Replies: 3
Views: 239
Posted By erad
My recommendation would be to go with what you...

My recommendation would be to go with what you already have. Yes - there is a chance that the transfer case may fail somewhere, and Mr Murphy says it will fail in the worst possible place, but the...
Forum: Generation 4-4 Pajero 1 Week Ago
Replies: 20
Views: 1,329
Posted By erad
I have fitted regular LED bulbs to the reversing...

I have fitted regular LED bulbs to the reversing lights on my wife's Outlander. Yes, they are brighter for sure, but the reflectors are designed for an incandescent bulb, and the light source of the...
Forum: Generation 4-4 Pajero 1 Week Ago
Replies: 2
Views: 273
Posted By erad
Those readings are the same as my NW Pajero, so...

Those readings are the same as my NW Pajero, so hopefully they are normal. I live at 880 m elevation, but these readings apply pretty well anywhere I travel, regardless of altitude. You are measuring...
Forum: Generation 3 Pajero 1 Week Ago
Replies: 10
Views: 458
Posted By erad
That wire is obviously an aftermarket addition....

That wire is obviously an aftermarket addition. It probably goes onto the engine - maybe the rocker cover bolts? If it was an original Mitsubishi wire it would be black and have different terminals....
Forum: ASX / Outlander/ Eclipse Cross 2 Weeks Ago
Replies: 7
Views: 634
Posted By erad
Aussieintas: You are a legend. I did what you...

Aussieintas: You are a legend. I did what you said, and it all works now> Wonderful. Now, to get the remote lock/unlock working from my key. It works from my wife's key, but not mine. I had a new...
Forum: Where the rubber hits the road. 2 Weeks Ago
Replies: 5
Views: 236
Posted By erad
As above - simply fill until the oil dribbles out...

As above - simply fill until the oil dribbles out of the filler hole. For what it is worth, my Max Elery W/S manual states early in the Transfer section 2.5 Litres as the capacity, yet in the summary...
Forum: Generation 2 Pajero 2 Weeks Ago
Replies: 3
Views: 237
Posted By erad
I don't know about the SWB, but in my NL, there...

I don't know about the SWB, but in my NL, there was no hatch to the top of the gearbox. I think I had the V5M31 gearbox, and eventually I found the switch on the left side of the gearbox, about half...
Forum: Generation 2 Pajero 2 Weeks Ago
Replies: 3
Views: 237
Posted By erad
on my LWB NL, I had the reversing light switch...

on my LWB NL, I had the reversing light switch short out, blowing the fuse. This, in turn, brought up the SRS light. Eventually, I found the reversing light switch on the side of the gearbox, and...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT +10. The time now is 05:44 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.