Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: old Jack
Forum: General Info 7 Hours Ago
Replies: 2
Views: 88
Posted By old Jack
Hi Peter, This thread may be of some...

Hi Peter,

This thread may be of some interest.
https://www2.pajeroclub.com.au/forum/showthread.php?t=53354

OJ.
Forum: Where the rubber hits the road. 10 Hours Ago
Replies: 16
Views: 1,911
Posted By old Jack
As the sidewalls are specifying max cold...

As the sidewalls are specifying max cold inflation pressure of 51 psi I would expect these tyre's to be Passenger construction and have a load rating of 112, so you need to be careful is venturing...
Forum: Where the rubber hits the road. 21 Hours Ago
Replies: 2
Views: 131
Posted By old Jack
Love New Tyre's.

Just fitted the 3rd set of new tyre's on the Challenger, after 143,000kms and 7 1/2 years, the last set lasted 74,000kms of hard, heavy work with about 30% off the bitumen. As usual I changed tyre's...
Forum: Where the rubber hits the road. 2 Days Ago
Replies: 9
Views: 463
Posted By old Jack
All good. I do not trust airbags when they are...

All good. I do not trust airbags when they are the only suspension upgrade or they are fitted to compensate for under size coils. At some time they will fail, and most times it is the most...
Forum: Generation 2 Pajero 4 Days Ago
Replies: 18
Views: 452
Posted By old Jack
That ATF has not been changed for a very long...

That ATF has not been changed for a very long time.
The system is likely to be filled with crud so even with a flush and a refill, you may need to drive it for a few thousand kms and then repeat the...
Forum: Generation 4-1 Pajero 4 Days Ago
Replies: 6
Views: 363
Posted By old Jack
The choice of coils that are standard height are...

The choice of coils that are standard height are limited and in most cases have a higher spring rate. At 200,000km you factory coils and shockers will be tired so expect a dramatic change in comfort...
Forum: Where the rubber hits the road. 5 Days Ago
Replies: 9
Views: 463
Posted By old Jack
I have corrected the typo errors in the OME part...

I have corrected the typo errors in the OME part number and starting spring rate for the OME 3110 coil.

Spring rates supplied in Nm/mm are correctly converted to kg/mm, they are not a 1:1...
Forum: Generation 4-3 Pajero 5 Days Ago
Replies: 8
Views: 447
Posted By old Jack
Are you doing a gravity bled or master cyclinder...

Are you doing a gravity bled or master cyclinder pressure bled top to bottom or an external source pressure bleed bottom to top?
Are you bleeding at all bled nipples including the expansion chamber?...
Forum: Generation 4-1 Pajero 6 Days Ago
Replies: 3
Views: 266
Posted By old Jack
Hi Aaron, In my opinion the Frontrunner full...

Hi Aaron,

In my opinion the Frontrunner full length rack are a stronger expedition rack than the Rhino Racks....
Forum: Where the rubber hits the road. 6 Days Ago
Replies: 9
Views: 463
Posted By old Jack
Based on the OME info I have on file and the...

Based on the OME info I have on file and the Ironman info supplied by the OP, the calculations are;

OME PN 3110 Medium Duty, Free length 400mm, 9.99kg/mm to 13.15kg/mm progressive spring rate....
Forum: PB -PC Challenger 2009 - 2014 1 Week Ago
Replies: 30
Views: 939
Posted By old Jack
Without taking the bolt out I believe it is a...

Without taking the bolt out I believe it is a Flange Head, 12mm diameter, 55mm plain shank, 25mm thread length and 3 mm tapered lead in.


OJ.
Forum: PB -PC Challenger 2009 - 2014 1 Week Ago
Replies: 30
Views: 939
Posted By old Jack
Front bolts MU000492. ...

Front bolts MU000492.
https://partsouq.com/en/search/all?q=MU000492

OJ.
Forum: PB -PC Challenger 2009 - 2014 1 Week Ago
Replies: 30
Views: 939
Posted By old Jack
The 2 bolts on the forward attachment are Part...

The 2 bolts on the forward attachment are Part Number MU000492, theses are a flange head bolt with a tapered thread lead in. The rear attachment bolt is a MU000493 this is a longer bolt and has a...
Forum: Generation 4-4 Pajero 1 Week Ago
Replies: 36
Views: 2,690
Posted By old Jack
I know from when I was doing heavy tow testing...

I know from when I was doing heavy tow testing when testing both Lockup Mate and Auto Mate for MM4x4 on the Challenger, that engine coolant, engine air inlet, engine load and ATF temperatures where...
Forum: Generation 4-4 Pajero 1 Week Ago
Replies: 10
Views: 564
Posted By old Jack
Hi Womble, Most unusual to have "N" flashing...

Hi Womble,

Most unusual to have "N" flashing on a Gen 4, more likely on a PB/PC Challenger or MN Triton with the Jatco auto.
Were you towing in "D" and were you going uphill?

OJ.
Forum: Generation 4-4 Pajero 1 Week Ago
Replies: 36
Views: 2,690
Posted By old Jack
I found this whilst doing a bit of research, ...

I found this whilst doing a bit of research,

As we pointed out earlier, high EGTs are the result of too much fuel for the available air. If you see EGTs climbing over 650 Deg C., the fastest way...
Forum: Where the rubber hits the road. 1 Week Ago
Replies: 7
Views: 294
Posted By old Jack
Hi BB, I am not sure is you were expecting an...

Hi BB,
I am not sure is you were expecting an increase in ride height over factory specifications when you had the ARB/OME suspension fitted but the empty non accessorised factory ride heights are...
Forum: Where the rubber hits the road. 1 Week Ago
Replies: 9
Views: 463
Posted By old Jack
Once you have the data, either post it, PM it or...

Once you have the data, either post it, PM it or email it to me.
Selecting the correct coils can be very hit and miss and it is particularly difficult with independent suspension where the load is...
Forum: Where the rubber hits the road. 1 Week Ago
Replies: 9
Views: 463
Posted By old Jack
Knowing the spring rate is only a small part of...

Knowing the spring rate is only a small part of the equation, you also need to know the free length of the coil and the total rear axle weight of your Pajero. Once you have these I can give you an...
Forum: Where the rubber hits the road. 1 Week Ago
Replies: 7
Views: 294
Posted By old Jack
Thanks for the info BB. Because ARB have...

Thanks for the info BB.
Because ARB have measured to the bottom of the rim, I need to now what the rim diameter is, so I can workout the centre of hub to under wheel arch measurement.

OJ.
Forum: Generation 4-2 Pajero 1 Week Ago
Replies: 7
Views: 303
Posted By old Jack
Coopers has just updated/refreshed the AT3 range...

Coopers has just updated/refreshed the AT3 range so the only difference I can see, from Internet research, between the AT3 and the Mickey Thompson AT38, is the AT38 has tread tie bars between the...
Forum: Generation 4-3 Pajero 1 Week Ago
Replies: 8
Views: 447
Posted By old Jack
Expansion chamber is also known as Dampner. no...

Expansion chamber is also known as Dampner. no many people even realise that they are often fitted to vehicles, so they are the forgotten component in the clutch system. This might be of interest....
Forum: Generation 4-2 Pajero 1 Week Ago
Replies: 7
Views: 303
Posted By old Jack
The Cooper AT3 LT has been around for 8 to 10...

The Cooper AT3 LT has been around for 8 to 10 years at least, and has got a reasonable reputation, some people love them and some hate them. I guess it depends on your expectations, use and the...
Forum: Where the rubber hits the road. 1 Week Ago
Replies: 7
Views: 294
Posted By old Jack
Hi Billybob, You are saying the suspension...

Hi Billybob,

You are saying the suspension is hitting on the bumpstops in both compression and rebound but you do not say under what driving conditions and loads.

So please described under...
Forum: Generation 4-3 Pajero 1 Week Ago
Replies: 8
Views: 447
Posted By old Jack
It is not uncommon that the slave and the master...

It is not uncommon that the slave and the master cyclinder fail under the extra load of a new HD clutch but from my experience it is rarely in such a short time.

In between the slave and the...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT +10. The time now is 03:55 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.