Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 254
Search took 0.01 seconds.
Search: Posts Made By: DibbyDibbyDJ
Forum: MM 4X4 2 Hours Ago
Replies: 11
Views: 341
Posted By DibbyDibbyDJ
Is there a PID associated with this i coud look...

Is there a PID associated with this i coud look for? that may have been deleted?
I may not get to drive these models, but if i can quickly plug in and get some info i will.
Forum: Generation 4-1 Pajero 2 Hours Ago
Replies: 6
Views: 199
Posted By DibbyDibbyDJ
I have seen one badly choked NS requesting it at...

I have seen one badly choked NS requesting it at 80km intervals. Unfortuanatly the customer had just bought the car and was returning it to seller, so we never got to see an outcome, or get much more...
Forum: Generation 4-1 Pajero 1 Day Ago
Replies: 6
Views: 199
Posted By DibbyDibbyDJ
A regen should only take a maximum of approx 10...

A regen should only take a maximum of approx 10 minutes to complete. The easy way to tell if it is trying to do one would be to use a scan tool to read the parameter.
Forum: Pajero Sport QE 2015 - 2019 2 Days Ago
Replies: 3
Views: 210
Posted By DibbyDibbyDJ
In the engine management data list are 2 items...

In the engine management data list are 2 items which refer to next regeneration required in kms. The items are numbered 193 and 196 and are named "Regeneration start distance"

An engine that is...
Forum: Generation 4-4 Pajero 5 Days Ago
Replies: 16
Views: 751
Posted By DibbyDibbyDJ
When the dealer does the indicator reset, if your...

When the dealer does the indicator reset, if your schedule is out slightly you need to do a “extra reminder” setting. Once you have done this, the dash button press will not work again until the...
Forum: Generation 4-1 Pajero 5 Days Ago
Replies: 25
Views: 977
Posted By DibbyDibbyDJ
Using a jet wash you WILL only get a low flow...

Using a jet wash you WILL only get a low flow through the DPF. The first time I washed one wash unsure if it was ok. But that is fine. But a very small trickle would perhaps mean a blockage. I have...
Forum: Generation 4-4 Pajero 1 Week Ago
Replies: 2
Views: 196
Posted By DibbyDibbyDJ
Yes, the ecu drives the egr valve motor to its...

Yes, the ecu drives the egr valve motor to its limits to ensure the potentiometer is working and the egr valve is in the closed position for starting.
Forum: Generation 4-4 Pajero 1 Week Ago
Replies: 4
Views: 290
Posted By DibbyDibbyDJ
Try your local dealers, some do wheel swaps and...

Try your local dealers, some do wheel swaps and have a few sets of steelies laying around
Forum: Pajero Sport QE 2015 - 2019 1 Week Ago
Replies: 9
Views: 370
Posted By DibbyDibbyDJ
As usual OJ is bang on the money with 15nm,...

As usual OJ is bang on the money with 15nm, Overtightening is a big problem. The standard bolts are no good on an impact driver and the threads stretch. Then when you unwind they strip out the...
Forum: Pajero Sport QE 2015 - 2019 1 Week Ago
Replies: 6
Views: 406
Posted By DibbyDibbyDJ
Rear shoes badly (incorrect procedure) adjusted. ...

Rear shoes badly (incorrect procedure) adjusted.
Exhaust manifolds cracking due to poor airflow
Oil leaks by fuel pump or timing case area
Seat trims rubbing against plastic surround on drivers...
Forum: Generation 4-1 Pajero 2 Weeks Ago
Replies: 12
Views: 679
Posted By DibbyDibbyDJ
Whoops. yep will not work on NS

Whoops. yep will not work on NS
Forum: Generation 4-1 Pajero 2 Weeks Ago
Replies: 12
Views: 679
Posted By DibbyDibbyDJ
Engine Temp 85c AT temp 60c fuel temp 45c ...

Engine Temp 85c
AT temp 60c
fuel temp 45c


No accessories or heater or lights on, steering wheel straight. Dual battery disconnected. I-drive and EGR defeat devices also cause issues.


...
Forum: Generation 4-4 Pajero 4 Weeks Ago
Replies: 15
Views: 1,197
Posted By DibbyDibbyDJ
There will be a build up of mould in your washer...

There will be a build up of mould in your washer bottle. Only way to remedy is to remove the bottle,thoroughly clean and flush out pipes and probably fit new jets. No point just fitting new jets,...
Forum: Generation 2 Pajero 4 Weeks Ago
Replies: 772
Views: 72,420
Posted By DibbyDibbyDJ
You heard it here first guys !!!!

You heard it here first guys !!!!
Forum: Generation 2 Pajero 4 Weeks Ago
Replies: 772
Views: 72,420
Posted By DibbyDibbyDJ
Congratulations guys Just heard that all...

Congratulations guys

Just heard that all dealers have received an email today explaining that air bags are now available for Australian vehicles covered by the NADI airbag recall...
Forum: Generation 4-3 Pajero 4 Weeks Ago
Replies: 15
Views: 839
Posted By DibbyDibbyDJ
The outer driveshaft hub nuts. The nuts may be...

The outer driveshaft hub nuts. The nuts may be tight, but the shaft may not be fully seated correctly.

Best practice is to remove the wheel and the centre hub nut. Then grab the shaft and try to...
Forum: Generation 4-3 Pajero 4 Weeks Ago
Replies: 15
Views: 839
Posted By DibbyDibbyDJ
No dash loosening required at all. Half a...

No dash loosening required at all.

Half a dozen screws and a couple of nuts holding glovebox surround on and nuts securing the inflator.
Forum: Pajero Sport QE 2015 - 2019 4 Weeks Ago
Replies: 6
Views: 528
Posted By DibbyDibbyDJ
Dealers should have no problem with catch cans...

Dealers should have no problem with catch cans and extra fuel filters being fitted.


Some will not be interested in the maintainance of them though, so dont expect them to drain catch cans or...
Forum: Mechanical 18-09-20
Replies: 70
Views: 50,182
Posted By DibbyDibbyDJ
Put them in clean and dry, with some supaglue for...

Put them in clean and dry, with some supaglue for lube only.
Forum: Pajero Sport QE 2015 - 2019 18-09-20
Replies: 8
Views: 831
Posted By DibbyDibbyDJ
It is listed for changing at every service ...

It is listed for changing at every service


https://www.mitsubishi-motors.com.au/customer-assistance/maintenance-schedule


If you are not on Capped price servicing, then ask for it not to be...
Forum: Introductions 16-09-20
Replies: 3
Views: 182
Posted By DibbyDibbyDJ
Welcome to the forum :drive[1]:

Welcome to the forum :drive[1]:
Forum: PB -PC Challenger 2009 - 2014 14-09-20
Replies: 11
Views: 660
Posted By DibbyDibbyDJ
When you get a quote for cleaning, it might be...

When you get a quote for cleaning, it might be worth getting a quote for new manifold.
Forum: PB -PC Challenger 2009 - 2014 14-09-20
Replies: 11
Views: 660
Posted By DibbyDibbyDJ
Never bothered changing the gaskets on 4D56....

Never bothered changing the gaskets on 4D56. Never had a problem, and done this many many times.

On Pajero you can’t reuse manifold to head gasket , or the copper washers on fuel return pipe, but...
Forum: PB -PC Challenger 2009 - 2014 12-09-20
Replies: 11
Views: 660
Posted By DibbyDibbyDJ
There are a few crevices inside the manifold...

There are a few crevices inside the manifold where the carbon collects. You won’t be able to get a brush to remove it. Just be sure there are no loose bits before the manifold goes back on.
...
Forum: Generation 4-4 Pajero 12-09-20
Replies: 7
Views: 449
Posted By DibbyDibbyDJ
There are 2 8mm holes that have to be enlarged to...

There are 2 8mm holes that have to be enlarged to 14 or 16 mm. No big worry
Showing results 1 to 25 of 254

 
Forum Jump

All times are GMT +10. The time now is 08:42 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.