Pajero 4WD Club of Victoria Public Forum Pajero 4WD Club of Victoria Public Forum

Go Back   Pajero 4WD Club of Victoria Public Forum > Search Forums

Showing results 1 to 25 of 426
Search took 0.01 seconds.
Search: Posts Made By: Calspec
Forum: Generation 3 Pajero 25-09-16
Replies: 12
Views: 2,299
Posted By Calspec
Bundybear, I would follow up more on the E25...

Bundybear,

I would follow up more on the E25 speed sensor error. If this is defective, it could block the mode change. The other two errors would then just be results of the fault with the speed...
Forum: Generation 3 Pajero 23-09-16
Replies: 12
Views: 2,299
Posted By Calspec
Get it hooked up to an analyser and look for any...

Get it hooked up to an analyser and look for any error codes.

Have you checked the three feedback switches under the LHS of the car, just below the B pillar. Unplug them and clean them too.
...
Forum: Generation 3 Pajero 21-09-16
Replies: 12
Views: 2,299
Posted By Calspec
Bundybear. Unplug the throttle position...

Bundybear.

Unplug the throttle position sensor connector behind the throttle assembly. Spray it with some WD40 or contact cleaner and then replace the connector. You will need a small...
Forum: Generation 3 Pajero 14-06-16
Replies: 18
Views: 2,520
Posted By Calspec
I have been through all that with my NM. Best...

I have been through all that with my NM. Best advise I can give is what has already been suggested. Get yourself, the car and the van to a towing specialist. They will inspect your current setup,...
Forum: Generation 4-2 Pajero 20-05-16
Replies: 7
Views: 925
Posted By Calspec
I am not up to speed with the differences between...

I am not up to speed with the differences between Gen3 and Gen4 in this regard. I didn't think there was much.

Are there three connectors together mounted under the vehicle on the left side, just...
Forum: Generation 4-4 Pajero 12-05-16
Replies: 18
Views: 2,611
Posted By Calspec
Exactly right. The maximum load any vehicle can...

Exactly right. The maximum load any vehicle can tow 'unbraked' is generally 750kg (GTM). So if the van has brakes fitted, then the towing vehicle must have a suitable controller fitted to be legally...
Forum: Generation 3 Pajero 09-05-16
Replies: 9
Views: 1,302
Posted By Calspec
AOB also sell on Ebay. I have bought an LED...

AOB also sell on Ebay. I have bought an LED lightbar switch for the NM and it fits perfectly.

This ...
Forum: Generation 4-4 Pajero 09-05-16
Replies: 26
Views: 4,127
Posted By Calspec
Just an opinion, coming from an owner of a 15 yo...

Just an opinion, coming from an owner of a 15 yo petrol NM.

If yours is still going strong, I would keep it. Your only gains are a slight power increase, 3 tonne towing and some mod cons.

I am...
Forum: Generation 3 Pajero 09-05-16
Replies: 3
Views: 680
Posted By Calspec
It's not a 5 min job and some preparation and...

It's not a 5 min job and some preparation and purchase is required.

Make up some r/a brackets to utilise the original mounting points of the meter to mount the Hema. Use the plastic clip mount...
Forum: Generation 3 Pajero 07-05-16
Replies: 3
Views: 680
Posted By Calspec
I'v got one I could sell you, but funny enough,...

I'v got one I could sell you, but funny enough, it's shot too. Compass doesn't work, but everything else is OK.

Personally, I wouldn't bother. Apart from a clock and a temperature gauge, it...
Forum: GPS Tech / Navigation 05-05-16
Replies: 4
Views: 2,267
Posted By Calspec
Avenza PDF Maps I find to be excellent. I have...

Avenza PDF Maps I find to be excellent. I have purchased on line maps like Hema, SPatial Vision and the national Geoscience Topo 250K series maps and they all work with this app perfectly. There is...
Forum: Generation 4-3 Pajero 04-05-16
Replies: 30
Views: 4,973
Posted By Calspec
I paid $242ea at KTAS at Reynella in March for...

I paid $242ea at KTAS at Reynella in March for the Toyo's. Have taken them over Mt Buller and very happy with there performance.
Forum: GPS Tech / Navigation 04-05-16
Replies: 4
Views: 1,560
Posted By Calspec
Jeff, Yes RAA at Mile End do have them on...

Jeff,

Yes RAA at Mile End do have them on display.

There is a store at Unley that will be able to show them to you and give you a much more detailed appraisal of there use and features. ...
Forum: Generation 4-4 Pajero 01-05-16
Replies: 18
Views: 2,611
Posted By Calspec
I have the Prodigy3 by Tekonsha. A very reliable...

I have the Prodigy3 by Tekonsha. A very reliable unit that once fitted and set up, needs no further attention. Unplug and remove when not in use, plug in when required and away you go.
Forum: Bits and Pieces 01-05-16
Replies: 4
Views: 864
Posted By Calspec
I have seen one of these as well. I agree they...

I have seen one of these as well. I agree they are VERY red, even a little too much so. Needs to be offset a little with some black fittings or something.
Forum: Generation 4-4 Pajero 27-04-16
Replies: 18
Views: 2,611
Posted By Calspec
You need a controller. Electric trailer...

You need a controller.

Electric trailer brakes are not simply on or off, unless you want to be painting No 11's all over the road with the trailer. They also draw a reasonable current, and your...
Forum: GPS Tech / Navigation 26-04-16
Replies: 8
Views: 7,600
Posted By Calspec
Not sure how you would go with the later models,...

Not sure how you would go with the later models, but this is my HN7 install in the NM. This would probably work for NP as well or any models that do not have MMCS fitted. I removed the...
Forum: Generation 3 Pajero 26-04-16
Replies: 4
Views: 521
Posted By Calspec
That could just be the valves being turned on and...

That could just be the valves being turned on and off along with some residual vacuum from the canister next to the actuator. You really need the engine running to test properly, as there is...
Forum: Generation 3 Pajero 26-04-16
Replies: 4
Views: 521
Posted By Calspec
Could be a vacuum problem or electrical problem. ...

Could be a vacuum problem or electrical problem.

4WD mode is brought on by a vacuum operated actuator under the car. Top and diff lamps flash until 4wd is fully engaged. Easy to have a look.
...
Forum: Generation 4-2 Pajero 09-04-16
Replies: 10
Views: 3,028
Posted By Calspec
Had EFS springs and Shocks for about 100k. No...

Had EFS springs and Shocks for about 100k. No problems at all with them, but their were quite firm. Handling was excellent though. Currently running OME/King HD combination and they are not as hard...
Forum: Generation 3 Pajero 08-04-16
Replies: 4
Views: 745
Posted By Calspec
If you get no green lamps at all on start up in...

If you get no green lamps at all on start up in 4H, then there could be a short circuit in the 4H circuit which causing your control module to shut down. Try disconnecting the electrical connectors...
Forum: Generation 3 Pajero 08-04-16
Replies: 4
Views: 745
Posted By Calspec
What happens when you attempt to start the car...

What happens when you attempt to start the car whilst it is in 4H?
Forum: Generation 3 Pajero 01-04-16
Replies: 7
Views: 684
Posted By Calspec
When you attempt to change from 4H to 2H, do the...

When you attempt to change from 4H to 2H, do the lamps for the front wheels flash or stay steady. If they stay steady then something has gone wrong when you have changed the lamps, do it again and...
Forum: Generation 3 Pajero 05-03-16
Replies: 15
Views: 1,741
Posted By Calspec
Great in the sand, just keep your tyre pressures...

Great in the sand, just keep your tyre pressures low (18PSI). Towing no problem - these things are built for it, but being petrol, you will notice it at the pump.
Forum: Generation 3 Pajero 14-02-16
Replies: 10
Views: 7,226
Posted By Calspec
Another thanks to those who posted images here. ...

Another thanks to those who posted images here. Finally located the drain and have cleaned it out. No more wet toes/carpets.
Showing results 1 to 25 of 426

 
Forum Jump

All times are GMT +10. The time now is 08:24 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.