Below Nav Bar
Collapse
User Profile
Collapse
-
Check your entry grab handles
My passenger side front roof grab handle in my 2015 NX came adrift on one side. The screw had come out. The other screw needed a nip up too. The other 3 roof grab handles don't get used much but I checked anyway and found each of them needed at least...
-
👍 2
-
-
A belated update. I bit the bullet and had a suspension check which indicated a loose right tie rod end. Replaced and 95% of issue has disappeared. I suspect the left one has started to wear but not enough to be problematic at the moment.
-
👍 1
-
-
I am highly sceptical we'll ever see a G5 Pajero in any form as I don't think it will be anywhere near economic for MM. Whilst Prado sales may well give some economy of scale, given the current G4 Paj isn't sold in Europe or USA its hard to see that...
Leave a comment:
-
-
When we travelled on dusty (and hot) roads, especially if travelling in convoy, counter intuitively we found having the a/c on recycle rather than flow through brought in more dust through the door seals, especially in the rear door. I believe the flow...
Leave a comment:
-
-
So, its not just me. My wife says the same, too. I thought that if I bought a new car I'd say to the salesperson, you have to be able to turn off, permanently, the beeping, the lane warnings, the lane retention pushing, engine stopping at rest, and...
Leave a comment:
-
-
Don't disagree with anything you've said above, although, as noted, not sure why one would want to reverse an airbag installation.
My decision was to get a lift with spring rates designed to deal with the daily (ie unloaded) drive weight...
Leave a comment:
-
-
-
👍 1
-
-
New Electrical standards for RVs, campers etc
Not sure if this article should be here or in campers and camping so might do both.
...
-
-
OJ, whilst I hold your advice and wisdom in high esteem, I struggle understanding your apparent antipathy to air bags. If one's vehicle which is normally unloaded for daily use but is used for towing a van or camper and/or is loaded up in the rear,...
Leave a comment:
-
-
I am going to have to do something about purchasing from somewhere like them. I have just had my valve clearances adjusted (first time in 150k) by a local, and otherwise excellent, mechanic, and was charged $316 for a valve cover gasket kit comprising...
Leave a comment:
-
-
I faced a similar dilemma in trying to decide where to put my second battery and DCDC charger. I, too, couldn't see a place to put my DCDC charger under the bonnet proximate to the second battery if I had the battery there. With hindsight (and forum...
Leave a comment:
-
No activity results to display
Show More
Leave a comment: