Buy a quality radiator from Natrad. They mostly use Koyo.
PS, a location and your car details in signature block greatly improve respondents ability to give best advice.
Below Nav Bar
Collapse
User Profile
Collapse
-
Springs hold the car up. Shocks control the suspension movement through travel.
If springs are correctly matched to suport load then shocks determine ride comfort....
Leave a comment:
-
-
Main issues with Joolca are wind and they need a minimum of 70Kpa water pressure to work. Careful placement of unit assists with first and a good quality electric pump the second.
They also chew though water fast to discipline needed for...
Leave a comment:
-
-
I would put spacers (nuts will do) between the BCDC and the plastic lid of the battery box. The BCDC gets hot in operation and relies on heat transfer of the whole shell for cooling and are meant to be mounted to metal....
Leave a comment:
-
-
No aftermarket plates clear the ARB tank.
Just cut that side of plate for clearance. I had to cut around 25mm off the transfer plate and notch the transmission plate similarly on my Boos....
Leave a comment:
-
-
There are 2 large rectangular shaped holes pressed in the front cross member on either side of the captive nut. You can get your fingers into the closest one and reach the captive nut plate and manipulate it out.
My plate actually separated...
Leave a comment:
-
-
Not sure if you've been to the monthly meetings or not yet but we normally suggest members new to 4wd to discuss with the training team (head of DTU Russell Chatfield will be on the door at monthly meetings when you come in, or email training@pajero...
-
👍 1
Leave a comment:
-
-
Out of curiosity how much oil do you get at 5000km?
Actual filter change frequency is 40,000km according to Mann & Hummel and from experience the cheap Ebay replacement filters dont work.
Interestingly the Ryco filter also fits...
Leave a comment:
-
-
Best to re check tension on hose clamps. Silicone relaxes more than the OEM ones....
Leave a comment:
-
-
I aim for 38-40 fr and 42-44 rear hot on road and work on 4/6psi Fr/R increase over cold on LT tyres....
-
👍 1
Leave a comment:
-
-
Great outcome and what would have expected with front springs better matched to rear. Glen will have checked rear alignment after the front spring upgrade but given your rear alignment specs are what I have run for years and similarly on other vehicles...
Leave a comment:
-
-
Its sounding like a faulty servo motor.
Have you done this check:
https://www.pajeroforum.com.au/forum...r-code-3-2-did
As you can only temporarily set the throttle...
-
👍 1
Leave a comment:
-
-
Rough rule is add half the value of the accessories to a std vehicle price and go down from there. Demand and location also affect price.
Leave a comment:
-
-
Been a few of these reported on forums with reflectors peeling after 18 months. Cheap, illegal rubbish....
Leave a comment:
-
-
-
MR GSR 18" will fit G4 LWB but front clearance is less than a piece of gravel.
Offset is +38 so also legal....
Leave a comment:
-
-
All NS petrol and diesel have Jatco.
Aisin was introduced in NT model and only on diesels....
Leave a comment:
-
No activity results to display
Show More
Leave a comment: